I have a zone 4 panasonic dmr-eh55, can it be world zoned?

You can either go into menu (pressing 'FUNCTIONS' button on remote) and look for 'RESTORE DEFAULT SETTINGS' or similar heading, or you can (while unit is on) on the front of the unit (not the remote) press CH UP and CH DOWN buttons together for 5 seconds - the unit will switch to standby. Give either one a try. (refer to page 60 onwards in your user manual - these pages detail 'settings').

If you cannot find your manual, it is available for download (free) - http://www2.panasonic.com/consumer-electronics/support/Video/DVD-Recorders-Players/DVD-Recorders/Operating-Instructions/model.DMR-EH55S.O#ts

I hope this helps in some small way. Thanks for asking FixYa!

It sounds like the DVD-RAM drive is about dead. Panasonic did not make them to be very durable.

Panasonic sells replacements at a high cost.

Replacement drives may work from used models including:
DMR-ES15
DMR-ES25
DMR-ES45
DMR-ES46

You can get the manual on the link below.

https://support.panasonic.co.nz/docstore/DMREH55%20Operating%20Instructions.pdf

Good Luck and please rate

Different Brand remotes use different codes for devices. Usually you can find web sites for your particular brand remote and get codes there.

If you receive your channels through your local cable company, nothing will change. The DMR-EH55 will continue to work normally.
If you receive your channels with your rooftop antenna you'll need a Digital to Analog TV Converter Box. The unit itself will not receive digital signals directly.

Remove the DVD and format the hard disk drive according to the user manual.
rgds
Luwangula

You can get one at Partstore.com

Buy a used DMR-ES15, DMR-ES25, DMR-ES45, or DMR-ES46 with a good DVD drive and swap out your bad drive.

i have the same player and wont play burned dvds

i have panasonic DMR-eh55 dvd and for the first time when i played that it was in japanies language thus i tried to convert the language in to english through remote control i selected one by one thus suddenly there came a message U302 and now when i play my dvd and as i press remote control it show on dvd screen U302. please how my remote will work again and how can i get the solution so that my remote control works....