Question about Hotpoint Ariston Aquarius WD420 Front Load All-in-One Washer/Dryer
An expert who has achieved level 3 by getting 1000 points
First switch off electrics , Remove door interlock , leave wires on .remove soap dispenser,remove front panel with controls 3 screws top of machine 3 screws bottom remove front casing you can now see door boot. remove sring note how boot came off refit is oposit to this noting top / bottom of seal ..Hope this some help-
Posted on Oct 03, 2009
How do i fit door retaing clip on wd420g
Posted on Sep 09, 2011
SOURCE: door seal needs to be replaced
For most front-loaders:
Plug off the wall mains. Remove the plastic clamp holding the
seal to cabinet & peel off the cabinet. Push downwards on the seal
close to the tub & the seal will come off - it's just held by a
spring on the periphery.
Lubricate the slot which fits over the tub with washing-up fluid.
Starting at the top, press the seal so the flange of the tub enters the
slot on the seal. Work your way round the using thumbs to force the slot
on the tub flange. When slot is on the flange all way round, fit the
spring which holds it on. The spring goes into a slot on the outside of
the seal. This is quite difficult and you may need another pair of
hands. Fit the outside of the seal to the cabinet - this
is easy and fit the plastic clamping ring.
Test for leaks before
using. Use rinse to test as the water level is higher. (There
is no glue anywhere, only clamps,etc)
Pl rate me nice for the free help!
Posted on Jun 08, 2010
410 views
Usually answered in minutes!
×