I know, seems like it's the same problem many times on this forum!
Here are the details:
Bulb has 527 hours
Projector powers on, solid green light.
Stays on for 1-2 minutes then powers off; no change in LED light colors - stays solid green
Have blown the projector out with canned air - a bit of dust was removed
Swapped known good bulb into projector - same results
Have also seen a slight bit of image "jumpiness" before unit powers down.
Color wheel appears to have no problems/cracks
Ideas?
Either the colorwheel motor is not getting up to speed to sync with the dmd chip, the wheel sensor is going, or the power supply needs replacing. you can try to replace them yourself or send it to an infocus authorized service center. try www.avsolutionsny.com . they're pretty good.
434 views
Usually answered in minutes!
×