Question about Vacuums
There is a plastic pop in trim cover which surrounds the switch itself. It will peel off revealing two screws which hold the switch in place onto the underside of housing.
However you must also remove the rear cone shaped motor housing by a series of philips screws where the motor meets the fan intake area. You should not have to remove any screws from the front are of the fan housing
Pay attention to these screws as they all face inward to the center area of the housing at the sides and underneath, but there are several lengths
Posted on Sep 28, 2009
Tips for a great answer:
Apr 16, 2014 | Kirby Heritage II Vacuum
Sep 12, 2010 | Kirby Generation 3 Bagged Upright Vacuum
Oct 04, 2009 | Vacuums
Apr 04, 2009 | Kirby Heritage II Vacuum
Oct 09, 2008 | Kirby Heritage II Vacuum
Jul 22, 2008 | Kirby G4 Bagged Upright Vacuum
May 13, 2008 | Kirby Heritage II Vacuum
Apr 18, 2008 | Vacuums
152 people viewed this question
Usually answered in minutes!