Red light on my machine

Usually increasing stitches is accomplished by knitting (or purling) twice in the same stitch.

How to Increase and Decrease Knitting Stitches For Dummies

Decreasing is accomplished by knitting (or purling) two stitches together.

...

try using www.ussearch.com

Hi Jennifer, After you login to FB. click on small F icon beside search frnd bar, later on left side you'll see your name and edit profile, below that you'll see "messages" just click on that and you'll get all your chat NOTE: if you have deleted any older chat then you wont be able to see that. .

It does not need to be descaled as this is not the descaling indicator...The water circuit needs to be primed. Turn the knob to the water drop and drain water into a bowl. Hold the water drop button down while this is happening until the red light turns green. Presto.

Hi
How can I help you with your problem Jennifer.
Thanks for using Fixya.

Hi Joni703:

I would recomend running your old Print Artist 8 in compatability mode, since you are dissatisfied with the new programs. to do so, install the program on your windows 7 system, if you have not tried already, and right-click on the corresponding desktop shortcut. When a menu comes up, left-click on properties. at the top of the properties window, click on the compatability tab. Next, click on the check box labeled "run this program in compatability mode for:" and pick the system you have used Sierra Print Artist Platinum on previously. It should function normally.

Hi

I have the original manual (a bit marked) but a better solution is to download the manual for the Swing Model from http://nettopdf.info/download.html?dl=aHR0cDovL3d3dy5jaGV6YmV0dGF5LmNvbS9pbWFnZXMvZ2FnZ2lhL2dhZ2dpYSUyMHBsYXRpbnVtJTIwc3dpbmcucGRm&t=pdf&name=Gaggia%20Platinum%20Swing%20Operation

The only difference is the manual, instead of electrical mechanism that moves the cup(s) up and down.

Cheers

Liz

May have to uninstall it first, then reinstall it.

Click START button, lower left corner
then click Control panel
then click on add or remove programs

*see if your product is listed(may be under BRODERBUND or other publisher name)
If it IS listed, uninstall it

Or sometimes the UNINSTALL is included in the CD options:
Insert the cd into the drive
go to my computer
find the cd drive
right-click the drive
select "explore"
Look for an Uninstall program

Hope this helps!
hansola

Hi there.
On the motherboard look for the front panel, it should be marked PWR and coloured green, also the plug that connects to it should be marked PWR_SW.
Have a look at these pictures for an idea >>>>>>





Good luck and thanks for using FixYa!!