My Amana top load washer fills & drains but doesn't wash?

Check lid lock

Hopefully you have it under warranty. You will probably need another wire harness. Double check your outlet to make sure it is grounded properly because they will 'nit pick' and tell you it is your fault for not having a properly grounded outlet.

u said drain works then u said it doesnt drain?

My washer will notwork it will not let the lid lock are fill with water

Hi,
The hoses are not hooked up right ...

Here is a tip that tells you how to fix that problem...

Water will not stay in Washing Machine

heatman101

sounds like the clutch is not properly engaging and if this is the case it usually meens it has to be replaced

Hi...

You need to check this

• Check the drain hose, it should be at least as high as the top of the wash tub, about 38 inches.
• The drain hose must sit loosely in the house drain. Do not seal the air gap around the drain hose or a siphon will occur.
• Check the drain control lever
• Test the drain control coils
• Check the cam bar

Good luck !!!

Regards
PCmania

Bad timer. Replace it.

I used another wash cycle. It has worked fine until today, so I can't think it is a hose situation problem. I will probably have to have someone come out and fix it.

You have too much of the drain hose inside the drain line causing the water to siphen out as its coming in. Pull some of the drain hose out and secure the hose. There should only be about 8 inches or so of the hose inside the pipe.