Wall oven completely turned off?

That doesn't sound good and is likely to be a Control Board issue. Turn it off tonight at the breaker and turn it back on in the morning. That is the closest you will get to a Reset.

The light in the oven is just a simple switch connected to the door hinge.

Um, is the fan working now? No? >> check power to oven

Circuit tripped? >> check for electrical fault / mice in wires

My oven seems to turn off but the fan keeps working! Takes about 1hr for the fan to turn off after l have turned oven off. Is this normal? Im quite concerned. Will be calling help line monday morning......

Your oven/micro combo is way overdue for replacement.

the same has happened to mine. i used it last night as usual and this morning the button just wont press?? did you manage to find out what was wrong?

thank you x

I had this same problem last night.. I have been having problems with the oven shutting off on preheat.. That sort of stopped. Last night lost power to the house. When it returned the oven was beeping and flashing PBR. I turned off the breaker for a few mins. last night and it returned. It was bugging me so much that turned it off the whole night. Woke up this morning turned the breaker back on and it stopped. I don't think this is the total solution. I am thinking that eventually I am going to have to replace power board in this oven. Hope it works!

Part # 71003424 runs around $185.00
It's a common issue in Jen-air ovens,the display burns out,the control itself will still work fine but you just can't read it.

mY 27" WALL jENN air blows cold air out the vents when on cleaning cycle. The red buttons aren't lighted. The door locks, otherwise it bakes fine. I wonder if it is really cleaning?

Try turning the power off at the breaker for 12 hours.

I had the same problem, tried turning the power off for a few minutes but that did not fix the problem.

Leaving the power off overnight seems to have fixed it.

First turn the electricity off by locating the breaker to the oven and turn it off. Now wait for an hour or so and turn the breaker back on, if the display turned back on, you need a control board (other manufatures call it a clock, PCB or ECC but it's the main elctronic board with the diaplay built in). If it didn't come back on, turn the power off again and make sure all the wire harness's going to the board are connected good. Turn the power back on and it the display still doesn;t come back on you need to replace the main electronic control board. By the way double check the model number and brand because it might be wrong. Please post back.