Holden VF Commodore. Will a VE radiator support panel fit a VF Commodore?

A 've ss' looks like it might be a Holden Commodore? All questions need FULL 'year make model' as first 3 words please.

It has a lot of fuses and the ones covering those are split up.

Holden Commodore (VE; 2006-2013) fuses and relays

Fuse Box Diagrams https://fuse-box.info > holden > holden-commodore-v...

Fuse Box Location. The fuse panel is located on the left side of the boot/cargo area, above the battery. Sedan:

..

The fuse box on a 2009 Holden Commodore VE is typically located in one of two places:

Under the hood: The fuse box is usually located on the driver's side of the vehicle, near the firewall. It is a rectangular box with a black or gray plastic cover. You may need to lift the hood to access the fuse box.

Inside the vehicle: On some models, the fuse box is located on the driver's side, under the dashboard. It is usually located to the left of the steering wheel, near the driver's door.

To find the specific fuse that you are looking for, you will need to consult the owner's manual for your vehicle. This will provide a diagram of the fuse box, as well as a list of the fuses and their functions. The manual should also provide instructions on how to check and replace a fuse if necessary.

If you are having difficulty finding the fuse box or identifying the correct fuse, it is recommended that you seek the assistance of a professional mechanic. They will have the experience and knowledge to help you locate the fuse and make any necessary repairs.

yes possible
will create electronic miss- matches to be sorted

Holden Commodore VZ VE V6 Alloytec Motor Engine HBE engine code AUD 1 250...

best ve commodore owners forum around
https://forums.justcommodores.com.au/forums/ve-holden-commodore-2006-2013.75

meant to do that
see what fitting a new cap does

my guess you are filling the radiator part up too much

leave it a bit low for expansion and to let fluid re-enter from the overflow by the radiator cap

best VE commodore owners forum around
https://forums.justcommodores.com.au/forums/ve-holden-commodore-2006-2013.75

Vehicle specific issue. I suggest you go here and the guys on the VE forum can help you with that........................


Forum VE Holden Commodore 2006 2013


====================================================

loosen rear wheels, jack up rear so wheels are free, fit safety stands , drain oil, remove wheels, remove 4 bolts holding axle bearings. remove both axles, remove bolts from tail shaft at diff pinion flange , leave tail shaft in transmission housing or oil will leak out, remove bolts from diff housing, the diff center can now be removed.

If this vehicle is newer than about a 2005 then its a dealer only job

to change the coolant in any engine you need to firstly remove the bottom radiator hose when the engine is cold not when the engine is hot and drain the whole system.
You then need to get some coolant from your local supplier and it will tell you on the container the proper ratio of water to cool it. Once you have put to cool it in top up the system with clean water.Regards

How to fit a tow bar to a ve commodore