My Kyocera edge won't turn on but when I put the charger on the light won't come on until I pull the battery out how do I get it to turn on

battery needs replacement.

This worked for me .. Put battery in charger , unplug and plug in charger repeatedly until it charges

Step 1 Charge the Bluetooth headset battery. The headset is fully charged when the indicator light turns off. Step 2 Unplug the charger and check the indicator light to ensure that the headset is turned off. If the indicator light is on, the headset is on. Turn off the headset by holding the multifunction button (the button in the middle of the headset) until the indicator light blinks red and shuts off. Step 3 Press and hold the multifunction button until the indicator light blinks red and blue to place the headset in pairing mode. Step 4 Turn on Bluetooth on your phone to start searching for available devices. When the search is complete, a list of available devices appears on the screen. On many phones, the Bluetooth options may be found in Settings. Step 5 Select the Kyocera Bluetooth headset name from the list. The phone prompts you to enter a passcode. Step 6 Enter "0000" using the phone's keypad to finish connecting the headset to your phone.

Make sure your phone is fully charged: plug it in and wait until the charge light (bottom right just below the screen) goes from red to white/green. Then turn the phone on using the power button (top edge of the phone just above the "a" in "Kyocera") by pressing and holding it for 5 seconds.
If the charge light doesn't come on when you plug it in, your battery may not be correctly installed, or you may need a new battery. Hope that helps!

I had the same exact issue.... try putting it on the charger, even if you think it's fully charged... If the light is red, leave it on the charger until it turns green, and then remove the battery for a second and then put it back in the camera before turning it back on..... try turning it on. If it still won't close, put it back on the charger. If the charger is automatically indicating a red light, that means you have exhausted your battery and will nee a new one... they cost about 5-11 dollars on amazon...... hope that helps...

I had the same problem but I held the power button for about 30 seconds or until it stopped blinking then I hit the power button again shortly after then it worked. I hope this solves your problem also.

try taking out the sim and blow the stuff out of it. Then put it back together and see what happens

No sorry, everything is fried... i learnt this the hard way!

hey, i had the same problem and i fixed it. i took the battery out and saw the 4 golden tabs behind the battery. there was two tabs that u could pull out. i lightly pulled them out a little bit. the problem was that the tabs wouldnt hit the battery to charge it. thats why it put the tri colored screen on the front. also my charger fit into the charging hole in the phone, but it had to be moved around to much that it did not fit exactly. I have been rough with the charger so it moved the inside of my phone around. i put the charger in the phone and moved it around gently around untill the light lit up on the front at the top by the word at&t. after it was completly charged, i turned it on and it worked perfectly. i hope this helps in whoever may have this problem because i know it sucks!
Thanks

make sure the phone is off, place the charger in the phone, immediately after the phone cuts on, remove the charger