Intex Inflatable Spa Model SB H10 Blower Malfunction

Make and model of vehicle would possibly help to get you an answer.

You would need to get that one fixed, try a local small appliance repair shop.

Parts &Accessories - Yard Inflatables

www.yardinflatables.com > Parts & Accessories

We have the largest selection of Holiday Inflatables! ... Yard Inflatables Replacement Fan AH-6 ... Gemmy Replacement .5a Fan With 12v/.67a Adapter ...

Christmas Inflatables - Outdoor Christmas Decorations ...

www.homedepot.com/.../Decor-Holiday-Decorations...

The Home DepotShop our selection of Christmas Inflatables in the Decor Department at The Home Depot.

Christmas Inflatable ' eBay

www.ebay.com/bhp/christmas-inflatable

eBayFind great deals on eBay for Christmas Inflatable in Christmas Yard Decor. ... 4 Ft Waterproof Inflatable Santa Claus Christmas Decoration Lawn Outdoor Art ... It has been used a few seasons, the train lights up inside, some lights may not work , bulbs may need replacing. ... Comes with ul listed adapter, stakes tether .

Inflatable Christmas Decorations ' eBay

www.ebay.com/bhp/inflatable-christmas-decorations

eBay

You need to find out what code or codes are stored in the airbag control module > There are a lot of components involved in your airbag system : If you haven't had any training on these systems your best bet is take it to a ASE certified repair shop . People have been killed messing with these systems not knowing what they were doing .
The frontal SIR system consists of the following components:
?€¢
AIR BAG indicator located on the instrument panel cluster (IPC)

?€¢
Driver and passenger knee bolsters

?€¢
Inflatable restraint front end sensor

?€¢
Inflatable restraint PASSENGER AIR BAG ON/OFF indicator located on the instrument panel

?€¢
Inflatable restraint Passenger Presence System (PPS)

?€¢
Inflatable restraint I/P module

?€¢
Inflatable restraint I/P module disable switch

?€¢
Inflatable restraint seat position sensors (SPS) (left/right)

?€¢
Inflatable restraint sensing and diagnostic module (SDM)

?€¢
Inflatable restraint steering wheel module

?€¢
Inflatable restraint steering wheel module coil

?€¢
Inflatable restraint wiring harnesses

?€¢
Seat belt pretensioners (left/right)

?€¢
Steering wheel and column

see the diagram attached. God bless you

why are you working on a car, and for sure dangerous air bags book free. RTM
open the book what does it say...???
its not like Christmas lights, and chevy chase.
read the FSM or at alldata.com
i hope you know,not to be in harms way, right,???????
please be safe, around bags.... ok?

• B0041

CIRCUIT DESCRIPTION
The inflatable restraint side impact module-LF deployment loop consists of the inflatable restraint side impact module-LF, the inflatable restraint side impact module wiring harness, and the side impact module-LF high and low circuits. A shorting bar used within the side impact module-LF connector shorts together the side impact module-LF high and low circuits when the connector is disconnected. This helps to prevent unwanted deployment of the inflator module during servicing. During a side or frontal crash of sufficient force the inflatable restraint Sensing and Diagnostic Module (SDM) allows current to flow through the deployment loop in order to deploy the side impact module-LF. When the ignition is turned ON, the SDM performs continuous diagnostic tests on the deployment loops to check for proper circuit continuity and for shorts to ground or voltage. If a malfunction is detected, a Diagnostic Trouble Code (DTC) will be stored in memory.

CONDITIONS FOR RUNNING THE DTC
Ignition 1 voltage is within the normal operating voltage range.

CONDITIONS FOR SETTING THE DTC

• DTC B0040 will set when the side impact module-LF deployment loop resistance is less than 1.3 ohms for 500 milliseconds .
• DTC B0041 will set when one of the following conditions occurs:
• Side impact module-LF high circuit is less than 2.4 volts and the side impact module-LF deployment loop is more than 6 ohms for 500 milliseconds .
• Side impact module-LF deployment loop resistance is more than 4.8 ohms for 500 milliseconds .
• DTC B0045 will set when one of the following conditions occur:
• Side impact module-LF high and/or low circuits is short to ground or short to voltage for 500 milliseconds .
• Side impact module-LF high circuit is less than 2.4 volts and side impact module-LF deployment loop resistance is less than 6 ohms for 500 milliseconds .

ACTION TAKEN WHEN THE DTC SETS
The SDM commands the AIR BAG indicator ON via Class 2 serial data.

CONDITIONS FOR CLEARING THE DTC

• The condition responsible for setting the DTC no longer exists and the scan tool Clear DTCs function is used.
• A history DTC will clear once 255 malfunction free ignition cycles have occurred.

DIAGNOSTIC AIDS
The following are possible causes of the malfunction:

• A short between the side impact module-LF high and low circuits
• An open or a high resistance in the side impact module-LF high or low circuits
• A short to ground or a short to voltage in the side impact module-LF high or low circuits
• The side impact module-LF connector
• The SDM connector
• A malfunctioning side impact module-LF
• A malfunctioning SDM

This is a common problem with the inflatable snow globe. Regretably you can only obtain a replacement on the planet kuku in the zooloo star system. Good luck as it is three million light years away.

Locations is what i believe your asking .
1 - Inflatable Restraint Front End Discriminating Sensor
2 - Inflatable Restraint Front End Discriminating Sensor Connector
3 - Inflatable Restraint Side Impact Sensor - Passenger (Driver Similar)
4 - Inflatable Restraint Side Impact Sensor - Passenger Connector (Driver Similar)


Engine compartment and center pillar post between both doors

Hello and welcome. code B0026 is for a airbag malfunction. this code will require a high end scan tool, like a GM tech 2 scan tool to check out.this code is related to a deployment loop problem on the drivers side of vehicle

• DTC B0026 will set when one of the following conditions occurs:
- The SDM detects the steering wheel module deployment loop resistance is greater than 4.8 ? for 500 milliseconds. - The SDM detects the voltage at steering wheel module high signal is less than 2.4 volts and steering wheel module deployment loop resistance is 6 ? or greater for 500 milliseconds.The inflatable restraint steering wheel module deployment loop consists of a steering wheel module, steering wheel module coil, steering wheel module high signal circuit, and steering wheel module low signal circuit. Shorting bars are used on the steering wheel module connector as well as the steering wheel module coil connector which will short together the steering wheel module high and steering wheel module low signal circuits when the connector is disconnected. This will help to prevent unwanted deployment of the inflator module during servicing. When the ignition is turned ON, the inflatable restraint sensing and diagnostic module (SDM) performs continuous diagnostic tests on the deployment loops to check for proper circuit continuity and for shorts to ground or voltage. If a malfunction is detected, a DTC will be stored.