How to clear error code H2-06

is the toner / drum cartridge third party or OEM if 3rd party replace with OEM

Btw, I’m available to help over the phone in case u need at https://www.6ya.com/expert/normanj_7893313f0751935f

http://www.copytechnet.com/forums/sharp/76512-sharp-mx-2300n-error-code-h5-01-a.html

image cartridge cyan need to be replaced

Btw, I’m available to help over the phone in case u need at https://www.6ya.com/expert/normanj_7893313f0751935f

H4 indicates "low temperature", possibly caused by a failure of the heater lamp or fuser. Sometimes this error is shown without an actual damage when the power cord is pulled without shutting down the copier first.

To cancel the error code, press [CLEAR], [AUTO], [CLEAR], [AUTO] in rapid succession. The display should go blank. Next, select 14 (clear low temperature code), press [START]. Finally, switch off and on the machine.

If there was no actual damage (i.e. power cord pulled), the machine should be OK again. If the error persists, immediately or after short time of operation, you will need to contact Sharp technical service for repair.

You press # * C * not # interups.
It is # * C * then enter 14.

GO ON LINE AND TYPE THE FOLLOWING:

SHARP SF2020 COPIER ERROR F CODE
ENTER
OR
WWW.SHARP.COM/COPIERS

ROD

Clearing a trouble code on a AR-M160 is a little different than the AR160.

Try "#" "interrupt" "clear" "interupt" "1" "4" "start key"

This should clear the error. Even if you replace the fusion unit you will need this code to clear the error

Hi,

H4 indicates there is a fuser error.

Try resetting it by the pressing the following buttons on the display in sequence,

#, interrupt, Clear, interrupt,

display should go dead,

enter 14,

then press print, This will clear the error code
press CA to get out and return to normal.
However if there is still a problem with the fuser, the code will return. Then you may need to have a tech look at what is the problem.
Hope that helps...

Lbcoaster

WHEN THE SHARP AR-5316 PHOTOCOPIER IS SWITCHED ON THE ERROR CODE 4H APPEARSAND THE MACHINE CANNOT BE OPERATED. IHAVE TRIED THE SOLUTION SUGGESTED JUNE THIS YEAR BUT IT DID NOT WORK. WHAT CAN I DO TO GET THE MACHINE TO WORK? IT IS VERY URGENT.