How to set the clock Chrysler crossfire - Crossfire Chrysler Cars & Trucks

Question edited for clarity.
Question moved from Computers to model category.

You soldered what 3 pins? If you are trying to bypass something, you are trying to fool two computers and it can't be done.

When you disconnect the battery, you have to reprogram the alarm and anti theft immobilizer.

https://www.google.com/search?q=2004+Chrysler+Crossfire+no+crank+no+start

and stuck in Park

https://www.google.com/search?q=chrysler+crossfire+stuck+in+park

..

This

https://www.crossfireforum.org/forum/all-crossfires/80790-my-hood-release-broke.html

and this

https://www.crossfireforum.org/forum/all-crossfires/64323-hood-release-cable.html#post764157

from this

https://www.google.com/search?q=2005+Chrysler+Crossfire+hood+release+is+broken

..

Put it into "set up" mode then adjust clock settings.

No. It has auto lamps.all newer vehicles have them. Some you can turn off. You have to have the light switch in the dash. If it is in the turn signal switch/ column. Your out of luck.

yes you can disable this see the local auto leck buy or the dealer

• The claim from Chrysler is that the top speed for the Crossfire is 158 miles. This is electronically controlled from the computer.

• Hope this helps and thank you for using FixYa.

Regards, Tony

http://shop.ebay.com/i.html?Model%2520Year=2005&_nkw=third%20brake%20light&_dmpt=Motors_Car_Truck_Parts_Accessories&_fln=1&_ssov=1&_trksid=p3286.c0.m282&Make=Chrysler

You can replace the headlights on your Crossfire easily by yourself. headlight image by Carbonbrain from Fotolia.com

When a headlight burns out on your Chrysler Crossfire, you do not need to rush to the repair shop to have it replaced. You can access the headlights in your Crossfire from within the engine compartment, allowing you to change the headlight yourself. The Crossfire uses an H7U headlight bulb, which you can find at auto parts retail stores or at a Chrysler dealership.
Difficulty: Easy

1. 1 Open the hood of your Crossfire to gain access to the headlight assemblies. Press down on the tab on top of the light assembly cover. Remove the cover and set it aside.
   
2. 2 Pull the electrical connection free of the bulb socket. Press the spring clamps securing the bulb into the light assembly. Pull the bulb straight out of position.
   
3. 3 Insert the new bulb in the same position. Ensure that the spring clamps secure the bulb. Press the electrical connection into place.
   
4. 4 Replace the light assembly cover and press it into position until it clicks, securing it in place. Repeat the same process on the opposite headlight if required. Close the hood and test the headlight operation.
   

At any Autozone,

I think there is a set screw in the side you have to loosen and then unscrew knob