Hi i have a Samsung 13Kg Wobble Tech. And when it is doing th3 spin cycle on Rinse or spine it start to make a grinding noise.

blocked or faulty drain pump

Sounds like your belt snapped or come off try to open up the back and you should see the belt and pulleys just simply put the belt over the pulleys a little bit then turn pulley and belt will slip rite on

Sounds a lot like a bad rear bearing. I replace them all the time

Sounds like a belt or clutch issue. What is the make and model #?

Hi, Do you know if the washer spins at all?
It sounds like the coupler has gone bad.
Please let me know if it spins at all.
I can send yyou instructions on changing the coupler.

Vic

chek the water elctrovalvles and replace it , this most be 1 solution another will the hyperstatic hose or sensor of load size

There is a transmission clutch that engages for the spin cycle. A gear has worn or broken a tooth. Replacement of the transmission hispeed spin cycle assembly is required.

The other comments are of no use. You must get parts from an Authorized Fisher & Paykel dealer, or have an authorized repairman service the machine.

Hi,
From your description, it sounds like the drum bearings have failed. If you grab the drum (power off, of course) it will probably wobble around a lot more than it should, and there might be metallic debris in the removable filter. White clothes may have been getting greasy spots on them recently.

Does any of this fit the bill with you? I hope it helps a bit to find out what's wrong.
If these suggestions do help you solve the problem, please give my reply a rating to help others judge my knowledge / guessing skills. If they do not, please add a comment with more details so I can try to help you further. Cheers, D

Bravo!

You may have a problem with the rotor position sensor. This sensor is situated on the motor windings and should really be replaced by a qualified tech.