Sieman's Electric clothes dryer Model # WTXD8300US

Can you look inside the door for your model number. I believe the problem is either a defective igniter or defective solenoid coils that open the gas valves=> 279834 Gas Valve Solenoid Set


4391996 Dryer-Igniter

Here is a Manual=> Atlantis_Neptune_Electric_and_Gas_Dryer_Service_Manual
I will be here if you have questions, Thanks Sea Breeze

You will need to replace the motor. Here is the new motor to order.

Maytag Dryer and FE code means power source "Frequency Error".
Invalid power... you will need a electrican to come out the power is not wired up right.

I would replace the wall receptacle before buying any dryer parts
Hope this helps (remember to rate and comment this answer).

This is the most common locations for thermal fuses and heating element on Whirlpool,Kenmore,Estate dryers. Check these fuses for continuity and replace the one that does not have continuity

Hello,

Welcome to FixYa.

While I can't promise you an answer, I may be able to help move you forward in the right direction or tell you how to find an answer if you'd like to clarify or elaborate on your inquiry.

Please also confirm the model number of the appliance in question is indeed a Bosch/Siemens WTXD8300US/01 dryer.

I'll watch for your reply and try to help in any manner I can.

Regards,

Macmarkus :)

I have a Kenmore 80 series electric dryer. The light comes on when the door is open so I know it is getting power but dryer will not turn on. Is the push button not working or can I reset the dyer?

Can you hear a click like always? If not then it has to be either the fuse, ignitor,or sensor. If you hear it clicking then the operator coils are dead. HERE is a link that shows pictures of these parts and locations.

If you need further help, reach me via phone at https://www.6ya.com/expert/dan_73bbd84fe1d95b61

most of the time the dryer vent hose,wall vent and dryer vent hole must be clear to allow the dryer to vent,also you can pull dryer hot put you hand on the dryer vent hole turn on and see if it is venting this will let you know if the blower wheel is turning, let me know what you find-mike

WHAT IS WRONG WITH YOUR DRYER?

For a detailed Dryer illustration, click below.

Gas Whirlpool Style Version 1
Gas Whirlpool Style Version 2
Gas Maytag Style
Gas GE Style
Electric Whirlpool Style Version 1
Electric Whirlpool Style Version 2
Electric Maytag Style
Electric GE Style
Warning! To avoid personal injury or even death, always disconnect your appliance from its power source--that is, unplug it or break the connection at the circuit breaker or fuse box--before you do any troubleshooting or repair work on your appliance. Also, because some components may have sharp edges, use caution while working on your appliance.

Electric dryers aren't very complicated. Here are some common symptoms that you may experience with your dryer:

There's an error code on the digital display

It doesn't work at all
There's no heat
It won't tumble
Drying is too slow
It overheats
It seems to run forever
It's noisy
It won't start
The light doesn't work
It blows fuses or trips the circuit breaker
My clothes smell bad!
My clothes are marked or torn

Jesse, does the door light come on? If not check the thermal fuse. You will have to open the top by pushing in on the two clips on each side. In back, on the right side of the heater you will see a thermostat and about 4 inches below the thermal fuse. Look at number 5 in the attachment. Makes sure to kill the power before going back there. You can either jump it out or ohm it out to make sure that is the problem. Part number for the fuse is LA1053.. Catriver..post back