Typical review
1.0 out of 5 stars What a NIGHTMARE! This cabinet was absolute misery from the get-go! Piece of JUNK.
Reviewed in the United States on November 17, 2019Verified Purchase
There were no written instructions, just a terrible diagram full of inaccuracies, there were missing parts and the parts and pieces that were there were horribly mislabeled. My dad and I were going to put this little cabinet together on a beautiful Sunday morning and 5 hours later we were both cussing, angry and ready to throw the thing right in the garbage. Screws came right through the cabinet and the lkow quality particle board literally crumbled in our hands. My mom came in to try to help stabilize it while we were attempting to stand it and she cut her hand on it a bled all over it. What a mistake it was to buy this piece of junk. Take my advice and do not waste your money!
Some help here.
https://www.google.com/search?q=Assembly+Instructions+for+Home+Source+Pantry..
SOURCE: assembly instructions
See the other posts about this bassinet. It is going to be recalled soon because it has caused a couple of deaths. Please don't use it!
SOURCE: need assembly instructions for body craft xpress
http://www.bodycraft.com/ or call 1-800-990-5556
SOURCE: Help Please ASAP. NEED Assembly Instructions
lbehrman
Here is the instructions on their site.
http://www.woodcrestmfg.com/instructions/instructions.htm
Hope this helps
Issken
http://www.fixya.com/users/issken
SOURCE: I need assembly instructions for a wilson and fish...
I didn't have my instructions either, but I finally figured it out. I do the top first. I'm 5'2" and I put it up by myself and this works for me. The leg connections are 6&5 with 6 being on the bottom with little holes near the base stand and 5 being on top. Add the corner connectors and side connectors to tops of 5. Out from the corner connectors add your 7's. Out from the side connectors the 10's for the long side and 8's for the short side. For the top corners add 4 then 3(it is that funky looking rod). In the middle connector add the 11& 12(this will be for the long sides).You will connect corner and sides with 1 (make sure to put the sliding connector on the rod with the Y's at the ends. On the top, top add the last rod. I think you'll be able to figure out how the canopy drapes. I hope I've given the right directions for yours. I put mine up yesterday.
SOURCE: need davinci roxanne crib assembly instructions
I found the manual here...
http://www.docstoc.com/docs/11983806/DaVinci-Decor---Roxanne-Crib
You may have to close an advertisement to view the instruction manual but it's there.
If this information was helpful, please take a moment to provide a "thumbs up" rating. Thank you!
73 views
Usually answered in minutes!
×