Maybe faulty CDI ignition module ? There are a number of components ( electrolytic capacitors ) in the module that can fail with temperature rise.
A test... Remove the ignition plug lead when motor has stopped after the 5 minutes and put a wire inside the plug cap and place end near a metal part of motor. Careful not to zap yourself... Pull starter and look for ignition spark. If there is no spark then probable fault is ignition module. If there is spark then problem may be in fuel system.

Do check vent on fuel tank is open.

Do check choke is turned to off once motor is running.

Do check the oil level as the low oil cutoff can cause shutdown and will result in no spark.

Mar 16, 2015 | Powerhouse PH3100Ri Inverter Generator...

1 Answer

Generator throttle hunts (revs up and down up and down) even with no load. It is factory set, no adjustments, low hours(24) 10w40 oil . can anyone help?

i need an authorization code for cs8.0
serial n.o:1
activation n.o:1238 7398 3743 8051 7005 5158 1190

Dec 09, 2013 | Powerhouse 2000 Watt Inverter Generator...

1 Answer

I have a PH3100Ri . It will not start with remote or with manual switch. The starter motor does not turn. Battery has full charge. Any ideas

My powerhouse PH3100 ri turns over with the remote and key but will not start , when it did run it ran for 10 mints and shut down and now it will not start at all

Jun 30, 2013 | Powerhouse 3100 Watt Inverter Generator...

1 Answer

How to change fuel filter on a PH3100Ri

Check to ensure you did not trip any of the amp switches. My generator acted the same way until I reset the switches.

Apr 11, 2013 | Powerhouse PH3100Ri Inverter Generator...

1 Answer

I have a Yanmar 4.5 KVA Generator running into a Trace 2.5 KVA inverter/charger, the inverter requires 205-220volts to operate,once the inverter connects the voltage drops on the genny over a ten second+-...

try adjusting the gen voltage at no load to run at 240 volts
when the load comes on it will drop back to 220-235 volts
check the load output from the inverter as 2.5 kv is nearly 80% of the genset duty cycle
4.5 KV is start up KV and the duty KV is around 3..8 kv not the plated 4.5 kv
to get constant 4.5 kv you will need a 5.5-6 kv unit
if the current draw from the inverter is excessive , the engine may not have enough in reserve to over come the load and will not pick up the rpms
take the gen set and the inverter to a shop that has a calibrated load bank to test accurate power output to determine if the engine needs an overhaul

May 28, 2017 | Electrical Supplies

1 Answer

Digital Inverter Generator XG-SF3600 running but no current

i have the same problem. I have AC from the windings but nothing leaving the inverter module..Its a sealed unit. There is virtually no parts back up service & if you can track down parts, they are quoting from $ 400 to $ 700 for replacement..If you expect this gen set to last like a honda or yamaha your mistaken..Dont buy chinese unless your short of folding stuff or you only use your gen set occasionally & for those that have had no trouble with theirs, its only a matter of time. trust me, they are a disposable item..

Sep 06, 2010 | Electrical Supplies

1 Answer

I have small portable generator with 220 vac in the philippines and a 12amp 12 v ac to dc converter. can i connect my 1000 w inverter to produce 120 vac becouse i dont have the batteries yet to run the...

no these are made to run off a batteries the 12 volt supplied from the gen is for charging batteries only and if the engine for starting the gen set has a battery their usual to small to run then their made for car style batterers.
hope this helps

Aug 14, 2010 | Vector 2000w Power Inverter

1 Answer

Heart Freedom 20 will not default to generator power.

First of all it is possible that the is no power going into the inverter,trace the input source to see if the connection from the generator is ok. check the fuse if it is broken if not, the contactor or switching relay in the inverter is bad

Apr 06, 2010 | Xantrex Technology Heart Freedom 20 12...

1 Answer

Problem with philips Powerhouse AW626 music System

try to invert your speakers cables and connect your right speaker cable to left output if the problem still happened you will have a problem in your amp and ask for help from good service center near you-------if the problem disappear you will have a problem in left channel----cable or speaker.

Jun 03, 2008 | Audio Players & Recorders

Not finding what you are looking for?

View Most Popular

Electrical Supplies

Power House PH3100 runs but isn't generating power

Powerhouse PH3100Ri 3000 Watt Inverter Generator With Remote Control S

Open Questions:

0 Answers

My conlog prepaid meter input and display unit is not functioning, hence I can't load in my token

Feb 18, 2021 | Electrical Supplies

0 Answers

Scania dc13 genset, always displaying on DSE 6020 MK2 that DC current and ECM error. Alternator after repair, checked by AVO meter 26,7 volt (good) but error on display monitor

Feb 15, 2021 | Electrical Supplies

0 Answers

Coleman Ultra 2500 watt generator service manual needed

Feb 15, 2021 | Coleman Electrical Supplies

0 Answers

Onan marquis 6500 LP only puts out 60 volts

Feb 12, 2021 | Electrical Supplies

Ask a Question

Usually answered in minutes!

Are you an Electrical Supply Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

PDF Manual

2100 powerhouse gen./inverter no run coming on

Add Your Answer

Attachments: Added items

Related Questions:

Power House PH3100 runs but isn't generating power

Why does my powerhouse PH3100ri generator run fine for about 5 minutes or so then dies and it will not start again in till it sets for 30 minutes or so then it will fire right up please help!!

Generator throttle hunts (revs up and down up and down) even with no load. It is factory set, no adjustments, low hours(24) 10w40 oil . can anyone help?

I have a PH3100Ri . It will not start with remote or with manual switch. The starter motor does not turn. Battery has full charge. Any ideas

How to change fuel filter on a PH3100Ri

I have a Yanmar 4.5 KVA Generator running into a Trace 2.5 KVA inverter/charger, the inverter requires 205-220volts to operate,once the inverter connects the voltage drops on the genny over a ten second+-...

Digital Inverter Generator XG-SF3600 running but no current

I have small portable generator with 220 vac in the philippines and a 12amp 12 v ac to dc converter. can i connect my 1000 w inverter to produce 120 vac becouse i dont have the batteries yet to run the...

Heart Freedom 20 will not default to generator power.

Problem with philips Powerhouse AW626 music System

Not finding what you are looking for?

Electrical Supplies

Power House PH3100 runs but isn't generating power

Open Questions:

My conlog prepaid meter input and display unit is not functioning, hence I can't load in my token

Scania dc13 genset, always displaying on DSE 6020 MK2 that DC current and ECM error. Alternator after repair, checked by AVO meter 26,7 volt (good) but error on display monitor

Coleman Ultra 2500 watt generator service manual needed

Onan marquis 6500 LP only puts out 60 volts

Related Topics:

Ask a Question

Top Electrical Supplies Experts

Marvin

Brad Brown

john h

Are you an Electrical Supply Expert? Answer questions, earn points and help others

Manuals & User Guides

Tenma 72-455A Audio Generator.PDF....

Tenma 72-455A Audio Generator.PDF....

Pramac_P6000S_Specification.pdf....

2100 powerhouse gen./inverter no run coming on

Add Your Answer

Attachments: Added items

Related Questions:

Power House PH3100 runs but isn't generating power

Why does my powerhouse PH3100ri generator run fine for about 5 minutes or so then dies and it will not start again in till it sets for 30 minutes or so then it will fire right up please help!!

Generator throttle hunts (revs up and down up and down) even with no load. It is factory set, no adjustments, low hours(24) 10w40 oil . can anyone help?

I have a PH3100Ri . It will not start with remote or with manual switch. The starter motor does not turn. Battery has full charge. Any ideas

How to change fuel filter on a PH3100Ri

I have a Yanmar 4.5 KVA Generator running into a Trace 2.5 KVA inverter/charger, the inverter requires 205-220volts to operate,once the inverter connects the voltage drops on the genny over a ten second+-...

Digital Inverter Generator XG-SF3600 running but no current

I have small portable generator with 220 vac in the philippines and a 12amp 12 v ac to dc converter. can i connect my 1000 w inverter to produce 120 vac becouse i dont have the batteries yet to run the...

Heart Freedom 20 will not default to generator power.

Problem with philips Powerhouse AW626 music System

Not finding what you are looking for?

Electrical Supplies

Power House PH3100 runs but isn't generating power

Open Questions:

My conlog prepaid meter input and display unit is not functioning, hence I can't load in my token

Scania dc13 genset, always displaying on DSE 6020 MK2 that DC current and ECM error. Alternator after repair, checked by AVO meter 26,7 volt (good) but error on display monitor

Coleman Ultra 2500 watt generator service manual needed

Onan marquis 6500 LP only puts out 60 volts

Related Topics:

Ask a Question

Popular Questions

Mini Maglite _ Can't open battery housing to change batteries

Generac 43903 standby Generator overspeed indicator on starting

Honda EU3000IS Generator Surging / Pulsing Problem

Ventrilo 3 stuck at synchronizing, cant connect.

Heath Zenith Security Light fixture with motion stopped working.

Top Electrical Supplies Experts

Marvin

Brad Brown

john h

Are you an Electrical Supply Expert? Answer questions, earn points and help others

Manuals & User Guides

Tenma 72-455A Audio Generator.PDF....

Tenma 72-455A Audio Generator.PDF....

Pramac_P6000S_Specification.pdf....