AIRCARE 1201. How can I get access to the fan blades to clean them?

From what you've described, it seems that the "A" setting may be a special or additional mode of operation. It could be an "Auto" or "Adaptive" setting that adjusts the fan speed based on the humidity level in the room, or it could be a specific function designed for a certain type of room. I recommend checking the owner's manual or contacting the manufacturer directly to find out more information about the specific function of the "A" setting on your Aircare (Valiant) Humidifier HD1409.

clean filter, filter is blocked not letting the air flow through correctly, take the filter out and clean it with warm water and leave to dry before refitting, can use soak but not to much as can damage the filter threads. but warm water will do the job to remove the particles its picked up.

I have a Feature Comforts Tower Fan that doesnt work? It has never worked

compressed air.may have to diassemble to access the fan blades.

dirty condenser coils or the condenser motor is not working, clean the coils with a vacuumm and brush and make sure the condenser fan motor behind the ref. is working. their is a access panel behind the ref. remove the access panel in rear and look for a motor, the blade should be spinning if the ref is running. be careful blade is sharpe dont touch blade if turning. motor runs around 29.99-89.99. and labor 75-125.00 depending on who u use and were u live . sometimes we find objects, pests caught in the blades. check all that before u call for servive . hope this helps.

Hi, check and see if the condenser fan motor is still running. Sometimes while cleaning, the fan blade gets hung up and will need to be freed. Migth have knocked some dust or insolation into the fan.
You can access the fan from the back
I hope this helps you. please let me know.

Vic

either drain is plugged up and water backs up and blocks fan rotation, or fan itself is bad and quitting occassionally. gently remove interior panels to access fan. is it running? if no check for 120 volts to it, usually there is a plug. got volts but no fan, fan is bad. if water backs up and is blocking fan you gently use hot water and shop vac to clean little drain hole in back bottom behind or near fan till you can blow easily through it with a short piece of hose over the hole. once clear the water can drain down toi the condensate pan by compressor and evaporate. these little fans are fairly cheap and come like a little module. be sure to observe the rotation and location of fan blade on the motor shaft . reuse the same blade unless it is loose . if replaced get same number of blades, rotation, pitch and diamater. usually they press on and off firmly with fingers.note how much blade protrudes beyond the shroud for location. not to far out or to close the the motor. good luck

there will be a oscillation driving counter wheel present inside it which is made of plastic tat would have got damaged or broken so replace the wheel then ur fan will start oscillating

This fridge has the coils that are not supposed to get dirty, but do anyways. Unplug it. You need to pull the fridge out and remove the panel at the bottom. You will be able to access the condenser from here, but it's kind of hard to get a narrow enough brush through it to thoroughly clean it, but get the most you can and make sure the fan blades are clean as well. Be very careful not to bend the fan blades, they are easily bent. Then make sure the area under the fridge is clean so the fan can easily move the air under the fridge.