I have an indesit washer dryer. It has started doing 3 beeps every 10 minutes or so throughout the cycle? It seems to be running fine. No flashing/warning lights just the beeping?

Lots of great replies, but I narrowed my "3 beeps" during wash to my daughter putting too much washing in the machine. It seems to have an 'overload' sensor that beeps when it detects too much weight. I initially thought it to be a blocked pump, but noticed it was beeping during washing cycle without the pump running. So worth trying a little less in the machine before you start taking things apart.

is bearings ok

Your Circuit Control Board is starting to Fail.... The Electrical Reset is the give away....

It seems to be set for a Wrinkle Guard setting.
Disable Wrinkle Guard and the machine will not beep and will stop at the end of the cycle.

I have the same model - it displays 10 minutes and keeps beeping in series of 3 (beep beep beep...... beep beep beep... etc..) ran through a cycle successfully but kept beeping like that the whole time. I unplugged it for 10 minutes but had the same symptoms after plugging it back in. I unplugged it for 24 hours, and that seems to have cleared the problem up.

Check things like the Filter / clear fluff...Make sure outlet hose if any is not kinked and passing air..Hope this helps..

unplug it for a few minutes and plug it back in again might be a pain but till you can get it serviced it should delete the fault code and run thru a full cycle. hope this helps a little.
Not a true fix just a work around.

best to you.

I have a smeg wd1 12c washer dryer showing error code e01 any idea how to fix it?
Gilly

since time specific i would be looking at the contro board as a problem