What would cause the fold table to slam down on a RAS turbo bend machine

You have tobe careful when you are folding picnic tables that you have followed all thesafety instructions:

• Make sure the diagonal folding legs are lockedwhen in use
• If you havefolded tables stacked on top of each other, don't pile them more than 10 tableshigh as they can fall

EHow has great instructions for an easy to make DIY foldingtable. Check it out below:http://www.ehow.com/way_5959759_diy-folding-work-table.html

There are a few differences between picnic tables and folding tables. For one, picnic tables don't usually fold. Picnic tables are only used outdoors. The main difference between picnic tables and folding tables is that picnic tables have benches attached on either side.

A folding table is a two or four legged table that can be flattened via hinges on each of the legs. Folding tables are very convenience because they tend to be very light weight and can save space.

There are 2 typs of folding tables: the ones that can be folded against the wall and the ones made mostly from fabric and are folded in the middle. There are so many types of them. You can try theses 2 links:
Folded against the wall (http://interiorforhome.com/baby-table-for-efficient-and-ergonomic.html) Regularly folded: (http://www.babytables.net/fortifying-style-with-folding-baby-changing-tables.html

faulty switch at the door or on the instrument lights itself

but i would be almost sure it is a door switch ...as over time and use they become worm and especially if you slam the door a lot
this will cause them to wear and bend and cause the door panel not to fully engage the switch

try holding the switch / or switches in fully to see if they go out a piece of duct-tape can also hold them in or a piece of folded cardboard to the switch and doorjamb and close the door so long as its in position it should better help you identify the issue at hand


hope this works and is a simple fix.

Flip over the picnic table and have a screw driver ready. There are 4 "braces" screwed into place to ensure the picnic table does not collapse on your children.

Once the braces are removed, you should be able to apply just a bit of pressure and fold the picnic table down flat.

Worn machine is possible cause.

There is a Optical sensor under the print head drive assy. You might have dust blocking this sensor.