Washer dryer. What does error code 3 indicate?

Check out this link. You probably need need a service call but try the power reset.

The F01 indicates a failed electronic machine control board. This error code can sometimes be caused by a glitch or power surge through the electrical lines. You may be able to clear this code by unplugging the washer for 5 minutes.
Dec 18, 2012

Error code on dryer F01 - Kenmore Elite HE3 Dryer - iFixit

..

Washer dryer displays error message E30, C3 or emits 3 beeps

https://www.electrolux.co.uk > support-articles > laundry
Sept 18, 2019 - Washer dryer displays error message E30, C3 or emits 3 beeps. The error is caused by water at the bottom or inside the machine.
Missing: efme517stt0 ‎' Must include: efme517stt0

Electrolux/Frigidaire combo beeps 3 times randomly ...

https://www.ifixit.com > Answers > View > Electrolux-F...
Oct 9, 2020 - Just curious if anyone would know why my Frigidaire stackable Washer/Dryer model FFLE3911Qw0 Beeps 3 times randomly and it does it all the ...

2 answers · 2 votes: Hi, Does this occur when the washer is in use? Don't know the answer but according to the ...
When I hit start Button, the dryer just beeps - Kenmore ...
7 answers
Nov 23, 2016
Why will my dryer turn on but won't start? - iFixit
3 answers
Sept 3, 2015
Frigidaire washer beeps through out cycle
2 answers
Mar 23, 2021
More results from www.ifixit.com

Any error code starting with "E" followed by numbers indicates a code meant for a service technician. Call your Duet dryer retailer or Whirlpool directly to set up a servicing appointment.

Read more : http://www.ehow.com/list_7528706_whirlpool-duet-dryer-error-codes.html

Hello tcavness609 - Are you certain the error code is F30? This manufacturer does not have a F30 error code for any washer. However, there is an error code F31 that indicates that the pressure senor is not communicating with the main control board. A professional will need to inspect the wiring between both parts and depending on the diagnoses either part will need replacing.

Long Drain If the drain time exceeds 8 minutes, the water valves are turned off and F02 is flashed.

Press PAUSE/CANCEL twice to clear the display.

NOTE: After 4 minutes the “Sud” error will be displayed, then 4 minutes later the F02 error code will be displayed.

Potential Causes

• Check the drain hose and make sure it is not plugged or kinked
• Check the electrical connections at the pump and make sure the pump is running.
• Check the drain pump filter for foreign objects
• If the above does not correct the problem replace the pump

If you need further help, I’m available over the phone at https://www.6ya.com/expert/craig_3fa289bf857b1a3c

Fdl is a code that indicates a door lock error. This error occurs because the washer senses that the door cannot be locked (even if it is). The door will try to lock six times before displaying the error code. You have a faulty door lock switch. Hope this helped and best wishes.

Hi, that indicates that either the fan motor is not working/ blocked or the dryer thermistor (thermostatic sensor) is playing up. Of course, the pcb reads the sensor so it could also be that causing the error.

I have a Kenmore HE5 Steam: after a power failure last week, now when you turn the dryer on and push"start" the cycle stops emediately and flashes PF...