Question about Aiwa Audio Players & Recorders

1 Answer

Aiwa AV-NW30 has no audio out, FM shows signal, functions work OK. No sound on headphones from AM/FM or CD? where to check for audio signal?

Posted by BILL LEEHAN on

Ad

1 Answer

Dariusz Zalewski

Dariusz Zalewski

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points
    Superstar:

    An expert that got 20 achievements.
    All-Star:

    An expert that got 10 achievements.
    MVP:

    An expert that got 5 achievements.

  • Master
  • 1,059 Answers

You would have to open the unit and check for signal right before headphone plug.

Posted on Oct 07, 2020

Ad

Add Your Answer

×

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

The FM function starts off great but loses reception after a couple of minutes and now the AM function has so much static you can not hear

AM FM TV Reception Guide and Directory » FM Reception ...

www.amfmreception.com/fm-radio/fm-reception-guide
Coax is a source of loss of signal from the FM antenna to the FM receiver and can also .... I believe the FM sound quality would strictly be a function of the tuner when ...It picks up the least off the side, but it does pick up some of the side. ...... THE ELECTRONICS so as not to short anything or to start the Great Chicago Fire of ...Missing: video

How to Avoid Distortion in Audio/Video Transmitters ' eBay

www.ebay.com > ... > Audio/Video Transmitters
An audio / video transmitter, or AV transmitter, is a wireless device that sends audioand ... As with all wireless signals, one can experience distortion or signal loss. ... AV signals are usually transmitted via wideband FM (frequency modulation) ... that of indoor transmitters, but the range drops off significantly the moment an ...

Jan 17, 2016 | Audio Players & Recorders

1 Answer

Hi: I have a aiwa nsx 800 mkII I hear left channel normal but the right channel sound very low ?qhere can I fix that?
Check first it is on all functions. If it is then it will be a power amp fault. As the unit has two channels both of which are identical to each other it's possible to check and compare each channel. So in your case the left hand channel parts are your guide to what is right. Compare first visually the two channels. If something looks burnt or damaged or wrong in the right, but it isn't in the left then you will have found the cause.
If everything looks OK, then carry out voltage tests, if you have a meter. Or a sound test. This involves touching with an insulated screwdriver the two channels while the unit is on. Never touch any part that there is only one of. Unless it's an IC and has two channels going in it. You will hear a buzz if it is working or produces sound. Again a good buzz in the left should happen in the same place as the right. When it's load at one point of a part but weak on the other, when it should be a loud buzz then you have found the faulty part.
Please however check first that it's not the headphone socket that is causing the problem. Sometimes the sound will be OK on headphones but not on the speakers. The socket the headphones fit into can cause this.

Oct 23, 2015 | Aiwa Audio Players & Recorders

1 Answer

Only picking up radio stations on headphones after plugging into tv audio
you have to go through the channels til u find the tv signal but the signal only goes to about 4 yrds

Sep 21, 2013 | Meridian Point 6 in 1 Wireless Headphones...

1 Answer

I have an aiwa AV-D57 receiver. I have issues with the function selection. A red light for the tape monitor stays on when selecting another function. While the tape light stays another light shows you...
You need to hit the tape monitor button again to turn it off. If the tape monitor is on, no other audio will be output to the speakers.

Apr 16, 2013 | Aiwa AV-D57 Receiver

1 Answer

My tuner will not work! I've had this unit for 4 years & it's always worked perfectly. Then yesterday, the tuner stopped working. "Tuning" flashes on-screen intermittently & no...
1. Verify the source of the signal - Look for any antennas that may have been hooked up, and verify connection has not been moved or removed.
2. Test with a different output by plugging in some headphones, and recheck the volume through the headphones.
3. Check that the A/B switch for the speakers has not been moved, and that they are switched to the correct speakers.
4. Try AM and FM for any signals both with speakers and then headphones.

Good luck!

Bruce

May 05, 2011 | Audio Players & Recorders

1 Answer

Can I use 6 ohm speakers on my 8 ohm aiwa av-x300?
Hello
You can use 6Ohms speaker in place of an 8Ohms speaker. No damage will occur to the set, but the quality of sound output will be a little bit less and the output will be a little bit high. OK.

Mar 31, 2011 | Aiwa AV-X300

1 Answer

Tuner works in display but no sound. Cd & tape work ok. R385 & R388 resisters have been hot. They measure 30 ohms. I think this is correct by their bands. The Panasonic site does not show...
R388 & R385 input +15 v out 7.5 v 27ohm x 2 .7.5v for tuner sys go to IC101 and IC 102....use oscillograph check all signal check ic302.... check Q512
2SD2144STA
HEADPHONE
MUTING SWITCH......

Jan 04, 2010 | Panasonic SC-AK100 CD Shelf System

1 Answer

Aiwa cx na555u
Dear shelnaaqua,
Please connect the headphone to your system and check the sound quality,If it sound good then the connection of the speakers are not ok. This system has HI & low frequency output. Connect woofer to LOW frequency output and tweaters to HI frequency.
please take trouble to vote for me if this solve your problems
ramesh22

Jun 07, 2008 | Aiwa NSX-A505 CD Shelf System

1 Answer

No AM or FM yet cd player works
Friend,

Maybe, there is a problem from the detector of you radio function to the amplifier. Try to check on it first or try resoldering from the detector section

Mar 06, 2008 | Sony XPLOD CDX-GT200 CD Player

1 Answer

No sound from stereo
If you can hear a hiss then the spkrs and amp are OK. It sounds like you're not on whichever source you're wanting to hear or it is on mute. Make sure ther is no function enabled that turns the sound off or over-rides it (like a tape monitor or AUX in...).

Sep 09, 2007 | Aiwa NSX-DS55 CD Shelf System

Not finding what you are looking for?

View Most Popular

Audio Players & Recorders

Related Question

The FM function starts off great but loses reception after a couple of minutes and now the AM function has so much static you can not hear

  • Audio Players & Recorders

Open Questions:

0 Answers

need to replace antenna for aiwa csd-ed87

Sep 11, 2019 | Aiwa Audio Players & Recorders

0 Answers

please show me how to adjust aiwa ca dw480 clock?

Sep 09, 2019 | Aiwa Audio Players & Recorders

0 Answers

How to reset a aiwa digital audio system cx-naj17

Jun 23, 2019 | Aiwa Audio Players & Recorders

0 Answers

please intimate the remote Number of AIWA NSX-K580

Jun 22, 2019 | Aiwa Audio Players & Recorders

Audio Players & Recorders Logo

Related Topics:

17 people viewed this question

Ask a Question

Usually answered in minutes!

Popular Questions

4 Answers
Unit clicks but won't turn on

Aiwa AV-D67 Receiver

2 Answers
Turntable belt

Aiwa PX-E860 Turntable

2 Answers
Aiwa CX-ZHT63 Display Trouble

Aiwa Z-HT65 Shelf System

1 Answer
Lost manual for AIWA CX-NA777

Aiwa Audio Players & Recorders

2 Answers
Uploading songs onto the Missil flashMP3 player

Aiwa HZ-WS2000 MP3 Player

Latest Celebrity Headphones Report
Latest Celebrity Headphones Report

View all Fixya Reports

Top Aiwa Audio Players & Recorders Experts

Grubhead
Grubhead

Level 3 Expert

5700 Answers

The Knight
The Knight

Level 3 Expert

76466 Answers

Cindy Wells

Level 3 Expert

6220 Answers

Are you an Aiwa Audio Player and Recorder Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

PDF Manual
Aiwa_av-d58-u_sm.pdf....

Aiwa AV-D58 Receiver

PDF Manual
Av-d67.pdf. user-manual-AV-D67...

Aiwa AV-D67 Receiver

PDF Manual
Avd67.pdf. user-manual-AV-D67 Receiver...

Aiwa AV-D67 Receiver

Loading...