I have a Mitsubishi wd 60735 and I took my tv out of storage and I let it warm up before use. Problem I am having is when I plug it in I'm not getting no lights at all on the front like there is no power and all my wall outlets work fine. Then a few hours later I hit the reset button and I got some lights on the front and the next morning nothing again?

My tv did this also the repair man came back the tv needed to be reset.all u have to do is unplug it for 30sec or so plug back in.

This set should have a self check:

A common issue and it may be your problem is dust and dirt inside the unit---the set intakes air from the front and exhausts it out the rear==I have seen several of these sets where removing rear cover and taking stthe set outside and blowing it with a air compressor clears the issue.

Fans and other critical items that get clogged or coated with a moderate amount of dust will cause this issue.

Based on model number indicated and fact it is not shutting down it most likely is the lamp reaching the end of its 2000 hour life.

Original lamps from Mitsubishi last longer than "generic" ones that often have half the life and are not as bright.

i hooked my pc yo my tv mitsubishi wd 60735 tv with the hdmi from pc to hdmi to tv and it fryed my tv

Sounds like your lamp/bulb is about ready to die. Here is a google shopping list for some replacements if you choose to DIY. http://www.google.com/search?q=Mitsubishi+WD-60735+replacement+bulb&ie=utf-8&oe=utf-8&aq=t&rls=org.mozilla:en-US:official&client=firefox-a#q=Mitsubishi+WD-60735+replacement+bulb&hl=en&client=firefox-a&hs=XxY&rls=org.mozilla:en-US:official&prmd=ivns&source=univ&tbm=shop&tbo=u&sa=X&ei=k7KtTZP4A4jk0QGYm6jHCw&ved=0CHwQrQQ&biw=1366&bih=650&bav=on.2,or.r_gc.r_pw.&fp=30e0fb8dc28dda8
Also if you need help on the DIY just come back. But a detailed reinstall can be found in the manual starting on page 75 which if you don't have can be found here:http://www.mitsubishi-tv.com/pdf/ownersguides/WD-60735.pdf. Also on that page is a part number and phone number to get replacement direct from Mitsubishi. Good Luck!

Try website like Youtube.com,search type in ur tv model,make and projection lamp replacement.U will have somebody,have a tutoring video doing it.

Did you recently replace the lamp? If you did then it might be the new lamp. I mistakenly bought an aftermarket lamp to replace mine and it would not work consistently. Apparently if it is not an Mitsubishi original lamp it has issues, because after I replaced it with a Mitsubishi lamp it worked perfectly fine.

Good Day,
It sounds like the TV has a bad COLOR WHEEL Part # 938P137010. 99.9% sure this will solve your noise.

Good Luck, Big Irish.

Hello zero_x08, 1) remove the cover of the TV and find the light engine. 2) using canned air blow dust from the mirro assembly 3) test the screen by turning the TV on after the system has warmed back to room tempurature. This should clean the mirror Thank you, Shuttle83 http://www.electron-age-technologies-llc.com