Question about Hotpoint Dishwashers

Open Question

Hi. I have a Hotpoint dishwasher LST216A which has stopped working. The system run part way through the wash cycle and then stops. I get the error code for lights 1,3&4 flash but can find a code or this make of washer . Has anyone seen this before?

Posted by Martin jackson on

Ad

Add Your Answer

×

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1helpful
1answer

LST216A - From start of all wash progs. - After about a minute (when it sounds as if pumping/draining) first 3 indicators + green on/off lamp start flashing ?. Water inlet seems o.k. !

Because of when it happens I would hazard a guess that it hasn't completed it's draining cycle. Check the outlet hose is not blocked, watch when it drains to see if there is a good flow. If you can hear the pump and it sounds normal I would look at the outlet hose first.
0helpful
1answer

Hi, our ariston dishwasher has stopped before the cycle finished and the water has not drained out. There are 2 flashing lights - the brush emblem and the spray ' on a tilt' emblem (the 2 on the...

Error messages.
The dishwasher is equipped with a
safety system which is able to
detect any operating anomalies.
These anomalies are signalled by
the rapid flashing of one of the
wash cycle indicator lights M.
If the indicator light for the soak
cycle flashes (see wash cycle table),
cancel the wash cycle by following
the instructions indicated in the
"Modifying a wash cycle in
progress" paragraph on page 4.
Now check whether there is any
water in the mains supply and that
the tap is turned on; if the error
message persists, then call for
technical assistance, indicating
which message appeared.
If the indicator light for any wash
cycle apart from the soak cycle
flashes rapidly, turn the appliance
off and call for technical
assistance, indicating which
message appeared.
Troubleshooting
You have checked
everything, but the
dishwasher still doesn't
work and the problem
persists?
Call an authorised service centre
near you and remember to mention:
? the type of malfunction
? the model mark (Mod?.) and the
serial number (S/N?.) indicated on
the rating plate located on the inner
door, to one side.

If you need further help, reach me via phone at https://www.6ya.com/expert/kelley_9a924afdf232bd4d

0helpful
1answer

My hotpoint aqarius dc26 dishwasher has stopped

this may be caused by a leak your dishwasher as a build in anti flood switch which stops water from entering when it leaks into the base of dishwasher . You may be able to check this for yourself by unplugging your dishwasher and slowly pulling it out and lean it back if water runs on to your floor you have had a leak .if at this point you turn it back on it might start to fill again .if it does start to fill turn it off again . it will need further examination to see why it leaking .if you feel you can't do this call your local engineer .
Feb 11, 2010 • Dishwashers
0helpful
1answer

Our hotpoint bf168 has stopped working. The rinse

Petere
Did you have ny luck solving your problem as my dishwasher has the same error
Lorraine
2helpful
2answers
1helpful
1answer

HOTPOINT DISHWASHER FDW60

Hi,

I have just had my dishwasher fixed by Hotpoint, as the heater was working and the dishwasher only stopped with the fast and delicate lights just before the drying process he replaced the main control board. This has solved the problem, I suspected the fault to be the thermistor as the heater seemed to be getting to hot but I had no idea where it was.

It turns out the thermistor is attached to the main control board and hangs down behind the front door that gives just a rough temperature level for the main control board.

As it's soldered directly onto the control board I would suggest replacing the whole control pcb for anyone with this fault unless you can find any spec details for the thermistor.
1helpful
3answers

Dishwasher does not stop

MY DAM DISHWASHER KEEPS ON RUNNING AND WANT NEVER STOP WHAT IN THE SAM HELL SHOULD I DO? H E L P M E!!!! I AM SO SICK OF MY DISHES PILING UP IN MY SINK..
Not finding what you are looking for?
Dishwashers Logo

Related Topics:

78 views

Ask a Question

Usually answered in minutes!

Top Hotpoint Dishwashers Experts

Michael Thomas
Michael Thomas

Level 3 Expert

3056 Answers

Brad Brown

Level 3 Expert

18803 Answers

Mike

Level 3 Expert

4377 Answers

Are you a Hotpoint Dishwasher Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...