Krups cofee machines. Loss of water - Krups Coffee Makers & Espresso Machines

open the machine, look at the wiring to the water heater. 1 cable is loose in the rubber/PVC cap. you have to solder it again.

as far as i know your best shot is to take the hose with you at a car parts store and ask them or high pressure fuel line with the correct size but dont thell them that its for a cofee machine

Look for the leak and fix it.

The mashine dont pull water from the water container and it ask us to press hot water , but nothing happend when we press , anyone knows how to sole this question ?

Allan

in our machine we wanted a stronger coffee so we adjusted the auto grinder (where the coffee beans are housed) to the finest setting thinking the finer the grind the stronger the coffee...after doing this the machine wouldnot make coffee...we sent it away while still under warranty and the tech said that the grind selection was too low so they just turned the grinder back up a notch and it worked fine ....dont know if this will help but it's worth a try!

That is a faulty thermostat or a defective control board.

Contact Krups and have the machine replaced.


Contact - Krups International

Yes it is tricky but easy once you know it. remove the bean container by pulling off the grind selector knob and removing the only screw.
Then remove the scute for the cleaning tablets. Then remove the two screws that were covered by the scute lid. Remove the water tank. Under the tank remove the two screws.
Then the trick where everyone seems to look for: The facade of aluminum can be moved off. Set the machine on the floor and pull hard upwards at the facade. This comes off (pull hard!) and four screw are uncovered. Remove them and pull then back housing of the machine (remove first the containers/drawers). Now the inner parts are freely accessible. You filter is the white valve connected to the three way valve (white plastic). You remove it by twisting it 15 degrees. Clean the inner parts (valve and spring) from coffee debris.

Hi,
for the error code 06. (this is what I got from a guy on a tech support line)

The issue is with the waterfilter. If you haven't changed it for a long time - change it. If you recently got a new one follow these steps:
- take the filter out
- unplug the machine from electricity
- plug it back in
- install filter (go into prog- service- install new filter)

It should remove the error. Haven't tested that yet, but that's what I got :)

Good luck

the o ring of the upper and lower pistons should be replaced

gose to : http://www.krupsusa.com/NR/rdonlyres/6907301C-7474-4ECF-857D-650657C83A4C/7923/FND1.pdf