Question about Bose Audio Players & Recorders

Open Question

Need wire diagram for Bose acoustimass25 series 2

Posted by Many Martinez on

Ad

3 Related Answers

Anonymous

SOURCE: wiring diagrams

wire colors for sony cdxgt51w

Posted on Mar 20, 2008


emissionwiz

Marvin

  • 85239 Answers

SOURCE: need a wiring diagram for 2006 f-series super duty 250

Ford sells a wiring diagram book, really detailed, about $35

Posted on Dec 11, 2008

Ad

SOURCE: How do I get the wiring diagram for Bose 321 GS Series II Answer

If you're looking for a hook up diagram, look for it at the Bose website. If you're looking for a service manual, you may also contact them, but I doubt they would sell you one. If you're interested in having your Bose repaired, please visit my website at audioserviceclinic.com. You may contact me there. BTW, I was a factory authorized service center for Bose for over 20 years.Thank you.

Posted on Sep 05, 2015

Add Your Answer

×

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

How do I get the wiring diagram for Bose 321 GS Series II Answer


If you're looking for a hook up diagram, look for it at the Bose website. If you're looking for a service manual, you may also contact them, but I doubt they would sell you one. If you're interested in having your Bose repaired, please visit my website at audioserviceclinic.com. You may contact me there. BTW, I was a factory authorized service center for Bose for over 20 years.Thank you.

Sep 04, 2015 | Bose Audio Players & Recorders

1 Answer

I need wiring diagram Bose audio input cable


Bose is proprietary. You need to either order it from them or Get a meter or continuity tester and write down the pinouts and make your own.

May 11, 2013 | Bose acoustimass 5 series II Speaker

2 Answers

Hello........ looking for a schematic for Bose 501 series 3 speakers. I need to replace the fuse in line with the tweeters.... its blown & does not have a value on it (unmarked, quick blow, twin lead,...


Did you find a solution? Dunno if it's much help, but I just today picked up some 501s - Series I I think - ugly heavy brown material grilles - but with a manual! No fuses in these, but booklet recommends installing your own in-line fuse holders (!?). Specifies a BUSS AGC-3 fuse for amps under 50wpc; or a MDL-2 fuse for amps over 50 wpc. Can be placed is series with either or the two signal wires. Very strange.... Robin

May 14, 2011 | Bose 501V Speaker

1 Answer

Not sure of how to wire these speakers ( internal ) Bose 901 series iv


Found on Google Search: "bose 901 internal wiring" You must first identify which series you have. The first two series were acoustic suspension, and used nine 8 ohm drivers in a series/paralel configuration. Series III through VI used nine .9 ohm drivers all wired in series. Series III and IV had an additional terminal for use only with the Bose Spacial Control Receiver. Series III through VI are easy to identify, as there are three ports sticking out the back of each enclose. The 1st two series have no ports.

Jan 17, 2011 | Bose 901 VI Main / Stereo Speaker

1 Answer

Bose 901 repair...


Bose 901s series 1-6 are all wired in the same way. that is nine one ohm full range drivers wired in series to produce around 8 or 9 ohms. No way it can be a short, think of the old christmas lights that were wired in series , one light went out, they all went out. I would check the wiring first to make sure no loose connections exist. The only way to access the wiring is to remove each driver from the cabinet. If all wires are intact, You may have a damaged driver. A simple test with a ohm meter will tell you. set to lowest ohm setting, each driver should read 1 ohm. If your speakers dont have the air tubes in back, you have series1 or 2 removing the drivers will not affect the vaccum, just replace the gasket material around the drivers.

Nov 08, 2008 | Bose 901 VI Main / Stereo Speaker

4 Answers

Bose 901 speakers the wiring inside


- Bose 901 Series I and II speakers have 8 Ohm impedance each.
- A row of 3 speakers in series gives you 24 Ohm.
- 3 parallel rows gives you finally 8 Ohm.

Front with 8 speakers (view from the rear):
(1) (3) (5) (7)
(2) (4) (6) (8)

Rear speaker is number (9)

Row 1: -(1)+ -(3)+ -(7)+
Row 2: -(5)+ -(9)+ -(2)+
Row 3: -(8)+ -(6)+ -(4)+

Oct 30, 2007 | Bose 901 VI Main / Stereo Speaker

Not finding what you are looking for?
Audio Players & Recorders Logo

Related Topics:

97 people viewed this question

Ask a Question

Usually answered in minutes!

Top Bose Audio Players & Recorders Experts

The Knight
The Knight

Level 3 Expert

76466 Answers

Muntejaya Ginting
Muntejaya Ginting

Level 3 Expert

10422 Answers

Marvin
Marvin

Level 3 Expert

85239 Answers

Are you a Bose Audio Player and Recorder Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...