How to recalibrate my amana washer - Amana Washing Machines

Admiral, Whirlpool, Maytag - Washer Repair - Not ... - YouTube

? 5:51
https://www.youtube.com/watch?v=oBihToN6dxs
Sep 6, 2013 - Uploaded by ApplianceVideo.com
Troubleshoot your Admiral Top Load Washer that has these following ... Speed Queen, Amana Whirlpool ..... Lid lock lightflases; no spin cycle.

Amana Washing Machine NTW5400TQ1 Troubleshooting ...

www.repairclinic.com/.../Washing-Machine...-/Amana-Washing-Machin...

Amana Washing Machine NTW5400TQ1 Troubleshooting & Repair Help. Amana Washing Machine problems. Washer won't spin · Washer is making loud noise ...

Amana Washing Machine Parts - RepairClinic.com

www.repairclinic.com/Shop-For-Parts/.../Amana-Washing-Machine-Parts

Huge selection of Amana Washing Machine parts in stock. Same day ... A small leak in front of the washer could be caused by a defective pump. OEM Part ...

Washing Machine Parts - RepairClinic.com

www.repairclinic.com/Shop-For-Parts/a11/Washing-Machine-Parts

Find your parts fast and repair your Washing Machine with our free repair help. ...Admiral · Amana · ARDO · Asko · Bosch · Crosley · Danby · E-Wave · Electrolux · Estate ..... A small leak in front of the washer could be caused by a defective pump..... Washing machine door lock and switch assembly for front loading washers.

How To Fix Front Load HE Washer Does Not Dispense ...

removeandreplace.com/.../front-load-he-washer-does-not-dispense-deter...

May 15, 2015 - HOW TO REMOVE WASHING MACHINE SOAP DISPENSER ...

You can try recalibrating unit. With your dial setting at the 12 o'clock position on the timer, you want to do these steps within 7 seconds. Turn timer knob left one time, 3 rights, one left, one right.
Then you will see all the lights blink. ( no time constraints after you see lights blink) Turn the knob 4 clicks to the right, then push the start button. Let it run until you hear the lid unlock and you see the done light lit up. When you replaced the timer, you needed to recalibrate the unit.

If the lights are not coming on, but you hear the pump, it could be stuck in the force drain mode. Let it run for about 2 minutes and see if it stops on it's own. If it does stop, try putting the unit into a regular cycle, if it lights up, you should be ok. If the pump does not stop, and lights are out, replace your control board. Make sure you follow recalibration instructions for machine to work properly.

sounds like the lid switch itself is bad or the control board is not recognizing the lid switch.

Place unit in diagnostic turn knob till rinse and spin are lit press the start button lights should go out press start again the lid should lock light on press again unlock and off

is this a whirlpool built amana? if so, its most likely a direct drive model, and when it doesn`t spin its likely a coupling between the gearcase and motor assembly...youtube has videos on how its replaced, which isn`t too complicated to do...good luck

The door is open. Be sure that the door is completely closed.

my amana ,soon i turn on always start to leak no much.?