Not getting any satelite signal anymore

The most common way to set those buttons is to tune in a station and then press and hold the button down that you want to set it to. It will beep of flash to show you that it has preset.

Contact Nexxtech on the web. Look for Support/Downloads/Manuals.

Often the trick is to hold one of the keys (time/mode?)
for about 3 seconds to go to the settings mode.

You may need to move the clock to a different location in order to receive the signal, and you may even need to place it outside overnight to find the signal. This link will take you to the instructions for a similar model:

http://www.lacrossetechnology.com/8117cit/manual.pdf

Bill B

i get the same on two of the same here only thing i can say is their tech support does not work and their customer service is next to none but perhaps they have turned off the satelite signal so that the 320's wont work anymore so that people have to go out and buy another 1 or perhaps the aliens shot down the satelite

check E-Bay or Amazon. Might have to contact the manufactorur

1)Press "SET" button for more than 3 seconds until digits of certain area blinks.
2)Press " ADJUST " button to increase digit reading value of year, month, hour, minutes...etc. of the blinking area ( Note: all adjustments are towards increasing increments only. Just cycle if accidentally past the required setting )
3)Press "SET" button once to jump from one area of adjustment to the next...example from calendar to month to hour to minutes to seconds....etc.
4)Press "mode" button to confirm all settings
5)Finished

There is usually a remote module mounted on the inside of the front of the tv that senses the remote signal. This controls all functions of the tv. If you are not comfortable in troubleshooting this, I would recommend a repair center.

i both a universal remote control from nexxtech for my electrohome tv a month ago .
And its not working anymore , i lost the code to reprogram it . Can you help me to get that code

Not a good plan! Yes you will have problems . It is best to home run a new cable.