How do i change the program speed on my elite hd power chair

It is a slow machine for indoor use and reverse is always a lot slower. The fact is is pulling to one side leads me to believe a batter might be failing, you have a bad connection, or the motor needs lubrication. I would take it into your local dealer for a service and tune up.

https://www.pridemobility.com/jazzy-power-chairs/jazzy-elite-hd/specifications.asp

..

Probably not. You need a programmer (a PP1) that will allow you to increase the factory speed. But it's probably set at 100% already. Other than setting the speed on the joystick to full and changing the programmed speed will you be able to get the chair 's speed increased.

Programmers are expensive and difficult to learn. Take your chair to a mobility service shop near you to get it programmed.

Hi invest in a BATTERY LOAD TESTER .this will give u an accurate reading on the condition of you're batteries..cost on E/BAY aprox $35.cheers

That is possible. Check the power circuit from the battery and see if there is any loose connections or resistance in the circuit via the voltage drop method. Here are some links that may help:

Jazzy 1113 ATS Parts

Redirect Notice

Redirect Notice

Yes, it is possible. If you take the chair to dealer who sells Pride, they should have a programmer available to change the settings on the joystick controller.

I take it you are talking about increasing the maximum speed beyond the maximum the chair is set for now! the max listed speed for the jet 3 is 4mps, so if your chair is doing that there is only changing a load of hardware to increase speed past that (it is very costly) if your chair is second hand it may be that the chairs programming has been changed to reduce the max speed say for in-door use or for elderly with slow reactions to better control the chair, if that is the case it depends on the controller you have it would need a programmer box, you can buy these on ebay and the like or you could take it to a mobility shop and see if they will change it, a lot of these shops will offer to do it free to try and get your future custom, it only takes a couple of mins, most will just plug in to the charge / data port on the controller, select from the menu and adjust the speed etc. hope that helps.

The chair may be in what they call SLOW MODE or the batteries are weak. If you have powered seating on the chair the seat has sensors that make the chair drive slow or not drive at all when the seat is tilted or reclined or raised. A sensor can go bad or get out of position. The joystick could have different programming for different drive modes. Try changing drive modes.

this is probally part of the motor controller program and you would have to have a tech with a progammer to make this change for you

jrw if you are asking to increase the programmed speed of the chair then you need a programmer (a PP1) that will allow uo to increase the factory speed. But it's probably set at 100% already. Other than setting the speed on the joystick to full and changing the programmed speed will you be able to get the chair 's speed increased Hope this helps you