HP LaserJet 2840: Page 'Too Complex' Help!
We would like to inform you that the error you are getting is not because of the printer driver installed on your computer but due to the USB speed setting on the computer.
. Please perform the following steps on the printers control panel.
a) Press the Menu button.
b) Press 2 on your keypad and then you will see Secondary Service/Service Reports.
c) Press the right arrow button until High Speed USB appears.
d) Press the Enter button.
e) Press the right arrow button until OFF appears.
f) Press the Enter button.
Print something from the computer to test for the issue.
The first print after performing the steps will take a little time to print but the remaining page will print in the normal speed.
Selection to turn off high speed USB clears out the memory and next print jobs works better, because the memory is no longer fragmented.
3. If the error persists, please perform the below steps:
NOTE: If possible, print a configuration page and menu map prior to performing a cold reset.
This will document the current settings for later reference as performing factory default settings will clear all the information stored in the printer.
Perform the following steps to restore the factory defaults using the device control panel.
a) Press the Menu button on the device control panel.
b) Use the < (Left Arrow) or > (Right Arrow) button to select Service, and then press the Enter button.
c) Use the < (Left Arrow) or > (Right Arrow) button to select Restore Defaults, and then press the Enter button. The device setting will revert back to the factory default settings and the device will restart.
×