Question about Toys

Open Question

Fisher fbx 1262 want charge it just cutoff and want charg

Posted by Chris Bad on


Add Your Answer


Uploading: 0%


Complete. Click "Add" to insert your video. Add



Related Questions:

1 Answer

Where does the charger plug in

you need remove the battery from his foot and charge it outside the toy.


Those batteries can get hot when charging - so best leave it dangling if possible so it wont damage anything.

Nov 10, 2013 | Mattel Fisher-Price Imaginext Big Foot

1 Answer

We have a power wheels Mercedes and have charged it but it won't start

check the battery with a multimeter and make sure it is showing at least 12 volts

Jan 01, 2013 | Fisher Price Fisher Power wheels Cadillac...

1 Answer

How long do you charge battery after you've done initial charge

a good rule of thumb is one hour for every amp hour that the battery is, so if its a 12ah battery then charge it for 12 hours

Jul 14, 2012 | Fisher Price Fisher Power wheels Cadillac...

1 Answer

Charging a fisher price power wheels

nope, way to many amps, could cause it to explode, you can get a replacement charger off of ebay for about $6 delivered

Apr 29, 2012 | Fisher Price Fisher Power Wheels Jeep...

1 Answer

Fisher Paykel washer keeps saying cutoff restart

The power supply is faulty in the motor controller.
Replace motor controller with new/Reconditioned board.

Apr 25, 2012 | Fisher and Paykel Fisher Paykel Intuitive...

1 Answer

The ac compressor clutch does stay on

Hello narto7
If you replaced the compressor yourself and tried to charge the system with those booster cans from the parts store, then air and moisture remained in the system. This will prevent you from getting the correct
charge and the correct pressure in the system. This can cause the lowpressure cutoff (on the accumulator right side of firewall) or depending on how much R134 was put in) the high pressure cutoff (on the compressor) to cut power to the compressor clutch assy. If this is
the case, have the system evacuated and charged with the proper
equipment and that should clear it up. However if it was charged properly, check the 2 cutoff switch's I mentioned. There should be power in and power out on both with the a/c on. There is also a relay
for the a/c you can check. But due to the split year in 95 it's located in
1 of 2 places, in the fuse relay block under the hood or under the right
side of the dash above the glove box. Remove the box for easier access. Hope this helps

Jul 06, 2010 | 1995 Chevrolet Suburban

1 Answer

My Scooter (Fisher & Paykel - Columbus) Will not charge

Hi. These machines will not charge themselves if the batteries are too flat. The charging system is run by the micro processor IC in the scooter. If the battery voltage is too low the the IC will not have enough voltage to operate.
Remove the batteries from the machine and charge in parallel on a 12 volt charger. Once they are charged, put them back in the machine, and try the scooter on charge again.
Good luck. Neil.

May 15, 2010 | Health & Beauty

1 Answer

My Scooter (Fisher & Paykel - Columbus) Will not charge

Batteries are finished. Replace them with fresh ... battery life is about 2 years.

Mar 28, 2010 | Health & Beauty

Not finding what you are looking for?
Toys Logo

Related Topics:

143 people viewed this question

Ask a Question

Usually answered in minutes!

Top Toys Experts


Level 3 Expert

85239 Answers

Tom Chichester

Level 3 Expert

61169 Answers

ray gallant

Level 3 Expert

71004 Answers

Are you a Toy Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides