Question about Carrier Heating & Cooling

Open Question

Hello, need answers for carrier ac code E9, also red light flashing on circut board (out door unit). Thanks

Posted by Keith on

  • Brad Brown Oct 04, 2019

    Hi Keith , I want to help you with your question, but I need more information from you. Can you please add details in the comment box? Model number



5 Related Answers


SOURCE: dacor convection oven cps127/130 failure code f1

i found my circuit/schematic tucked inside the back panel in a envelope, you have to remove the oven from the wall to gat to it and start un screwing the panels, i think it was on the top.

Posted on Sep 05, 2007


Don Berry

  • 230 Answers

SOURCE: carrier ac unit

This appears to be a Roof Top packaged unit. You will definitely need some help with this install. Your local Carrier distributer should have the installation curb kits and economizer etc.

Here is the most technical data I can find for this unit. Under the 50TFF section you will see the accessory dimensions. I hope this helps. (You will need adobe acrobat to read the file)

Posted on Jun 18, 2008


Ken Bledsoe

  • 306 Answers

SOURCE: Tonnage of my Carrier AC Unit

3 1/2 ton unit the 042 tells me.

Posted on Dec 11, 2008


  • 747 Answers

SOURCE: carrier furnace model # 58PAV090-14 fan runs but

See the link:

Posted on Mar 19, 2009

Mukesh Kumar

  • 3230 Answers

SOURCE: GE JGBP85WEB5WW - F7 / E9 Error codes

Hi there,

Well first of all you determine if problem is with the Key Panel or Control by-

1. Pushing CLEAR/OFF pad.
2. Disconnecting Ribbon Cable from control and waiting at least 32 seconds to see if Code recurs

If code recurs, problem is in the control. Replace control.
If code does not recur, problem is with the Key Panel.
This error code means Function pad button stuck or Bad clock: Unstick button or Replace Electronic Range Control (ERC).
Post comments for more help or information........

Good Luck!!

Posted on Mar 27, 2010

Add Your Answer


Uploading: 0%


Complete. Click "Add" to insert your video. Add



Related Questions:

1 Answer

Carrier furnace 58pav090-14 5 flashing red light, how do I determine which code it is please

The code is read short flashes first then long flashes. 3 short and 1 long would be a 31 code. usually on the door of the unit would be the codes and their explanation

Nov 20, 2017 | Carrier Heating & Cooling

1 Answer

I have an old Carrier N1340 air conditioner that works when switched on, green light flashes 4 times, for a few times then it shuts down. There is also a flashing red light inside that unit.

There will be a list of flash codes in your manual or on the inside cover of the unit indicating what the problem is eg. low pressure or high pressure alarm

Nov 15, 2016 | Carrier Heating & Cooling

1 Answer

Have a carrier 92 furnace. electric motor will not kick on...just hums. red light on circuit board

see this causes and fix it. God bless you
If the furnace won't run, check the electrical service panel for a blown fuse or tripped breaker. Also make sure the power switch on or near the furnace is turned on. Check the unit for a reset button and try it. Some units have a built-in breaker or fuse panel.
However you can have a missing 1 phase , test with the VOM, for to measure voltage. Or motor need repair for winding trouble,bearing.If you do not have enough experience call some electrician.
God bless you

Oct 08, 2012 | Heating & Cooling

1 Answer

Carrier 38 leo 30320 ac unit....when the compressor shuts off the fan keeps running. a rap on the control panel shuts it off. I when changed the contactor the inside unit stopped working so I put the

Hello, if the indoor blower runs nonstop a relay in the intergrated control board faulty and the whole board must be replaced, you can get tap the board to stop the blower but eventually the board will need to be replaced. If the contactor is clicking that means it is receivingpower from the indoor unit

Jun 16, 2012 | Carrier Heating & Cooling

1 Answer

Hi sir, We have 7 nos carrier split ACs iln our office, all are working good condition, I need some spare parts of it, remote is ok but split sensor cercute board is problem, we need sensor circute board...

You can use carriers site here:

I would recommend you use the "contact us" link. It may take 3 to 4 days to get an answer but they do answer.

Hyderabad ap india was not on their list. (See above link for closest dealer)

Thanks for choosing FixYa. Kelly

Sep 27, 2010 | Carrier Refrigerators

2 Answers

I have an electra split unit a/c. A red light is on with a sign like an S with two lines. What does it mean? thanks

look around the circuit board or on the board or diagram it will tell you the trouble codes for the light flashes

Aug 20, 2010 | Heating & Cooling

3 Answers

My blower blew a 3 amp fuse..i replaced it....the blower is running...but the ac wont kick back on

why did fuse blow thats what i would figure out? check for power at compressor it maybe locked up(you haft to reverse polarity to unlock)!! :)

Jul 05, 2009 | Heating & Cooling

1 Answer

Gas pack will not start

Check the code reading on the wiring diagram or the door and see what it says. Control boards usually have multiple trouble codes they can blink. Is your Inducer motor running? Any noises at all? Turn the breaker or dissconnect off and reset its sequence. see if you can get it to do anything. If you have a volt meter see if you have 24 volts coming out of your transformer. Make sure you have 24 volts on your W and C terminal on the control board to verifiy your t-stat is telling the unit to come on

Nov 16, 2008 | Carrier 38CKC036 Air Conditioner

Not finding what you are looking for?
Heating & Cooling Logo

Related Topics:

114 people viewed this question

Ask a Question

Usually answered in minutes!

Top Carrier Heating & Cooling Experts

Dennis Boxerman

Level 3 Expert

1305 Answers


Level 1 Expert

26 Answers


Level 3 Expert

747 Answers

Are you a Carrier Heating and Cooling Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides