Question about MTX Car Audio & Video
On your amp, there should be a switch (on the side probably) that has "LP", "HP", and "FULL" or "OFF". This is a switch for the low pass/high pass filter. Switch it to "LP" as this will allow only low frequencies to go to your subs, what you want. If you don't have that switch, go to an audio store or online audio supplier and get either a low pass filter, band pass filter, or a cross-over, and follow the wiring diagram that comes with it to filter out the high frequencies before they get to your subs.
Posted on Oct 09, 2007
You will need a 6 Gauge wiring kit with a 50amp fuse to the battery. You can verify this by looking at the kits being sold on the internet for 600 Watt car amps.
Posted on Apr 18, 2009
when you do find a replacement use Kapton tape to reduce the heat on the parts use around component and around surrounding area except the place to be soldered
Posted on Jul 05, 2009
SOURCE: i have a boss rt645
That all depends on the wattage of the subs. also the independance of the subs. If your amp is 1400 watt, maximum you want is 2 600watt subs. if your subs are higher you will blow your amp eventually as your amp isnt powerful enough to pump out to that level.You should never have your amp fully turned up to max, 80% is perfect and will not make your amp blow. Hense why you want your subs less than the max output of your amp.
Posted on Mar 04, 2011
Tips for a great answer:
Feb 20, 2015 | Sony XM ZZR3301 Xplod 600 watts RMS at 2...
Nov 11, 2013 | Car Audio & Video
Jul 15, 2011 | Car Audio & Video
Jul 27, 2010 | Car Audio & Video
Oct 19, 2009 | MTX X Thunder 300XD Car Amp
127 people viewed this question
Usually answered in minutes!
Step 2: Please assign your manual to a product: