OkI C5800 error 923. I replaced the black drum and after turning the printer on/off get the same message. Is this a K-ID motor problem?

SOURCE: Oki c5800 laser printer

http://www.c5800.co.uk/index.asp?printername=C5800&menumode=0&content=C5800downloads

At the bottom you will see the file C58uEN1.pdf

Go to page 89

Posted on Mar 26, 2008

SOURCE: OKI C5800 ERROR MESSAGE- DRUM

hi!!!
try to check the drum first!!!
clean it with the dry tissue?
there a lifespan of the drum
i have the same problem with that.
my drum capacity is only 30,000 copies
so then i replaced it! and works fine now

so try to replaced the drum it might on it capacity
or clean it

try to email me [email protected]

Posted on Sep 19, 2008

SOURCE: Have an OKI Printing Solution

Found this at Fixyourownprinter.com

1. Turn machine on while pushing and holding the TWO up/down menu buttons at same time.
2. Menu window will show "OKI USER"
3. Scroll to " Engine Dialog Mode" is indicated. Push Enter button.
4. "Diagnostic Mode xx.xx.xx S-Mode is indicated.
5. Scroll to "NV-Ram initial" is indicated. Push ENTER.
6. Window shows "NV-Ram- Initial Table 1".
7. Push ONLINE and ENTER Buttons simultaneously and HOLD for 10 seconds after you see "Executing Reset" appear in menu window.
8. Restart printer.

All toner, drum, fuser and transfer figures return to 100%.

Worked for me when I had the same error. Hope it helps.

Posted on May 26, 2009

SOURCE: have a oki c9800 ...gives error 923

923: Error - Black Image Drum Lock Error
The K ID unit is not operating
properly.

Check to confirm that Image Drum is seated properly.
Check to confirm that the K ID
unit is in position.
Replace the K ID unit.
Replace the K ID motor.

Posted on Mar 29, 2010

SOURCE: My Oki C5800 is not printing any black- toner is

First of all try cleaning the black LED head with an alcohol wipe, next check the connection to the black LED head and make sure there is nothing blocking the light between this head and the top of the image drum. It may also be worth swapping the LED head between colours to see if the problem moves colour or stays with black. If after moving the head the problem still happens with black then it may indicate a problem with the image drum or an electrical problem. If you have another unit you could try swapping the drum and toner between units.

Posted on Nov 10, 2011