Question about Timex Watches
I need to replace the battery for a Timex analog Winnie the Pooh watch. What type of battery doI use.
Take the back off & have a look.
Posted on Sep 08, 2019
Watch battery #377
Posted on Sep 08, 2019
What would do is take it to a Walmart watch department they have batteries and can help you open the back. Assuming you can't open it
Posted on Sep 07, 2019
SOURCE: watch battery replacement
I have a Timex Expedition Indigo with a metal case. Not sure of the exact model number but on the back there an M6 below Expedition. Anyway, I had the same problem of snapping the back back on. I found a "battery" website that had some suggestions that should be typical of any snap back case watch. http://www.online-batteries.co.uk/whichbattery.shtml specifically they said that when you try to press the back on it must be flat (not one edge down as I had been trying) Put the watch face down on a non scratch surface and press with both thumbs evenly. If that doesn't work a press will be needed. If you have a vice a couple of blocks of wood to distribute the load on the front and back may work, otherwise take it to a jeweler with the proper equipment. The thumb routine didn't work for me. I have a vice but figured many wouldn't so I tried something else first. I put the watch face down on a piece of wood. I found a small 2" long scrap of wood (3/4" x 1.5" approx) that spanned the back. I centered the back (aligned properly) placed the block of wood squarely and centered across the back and tapped the end of the block with a hammer. First try didn't work, second one did. I used a rubber mallet as the hammer but a regular hammer or other heavy object would work. The trick, I think, is to get everything lined up and square so the blow is centered and even. Also, I'd suggest cleaning the back and the groove in the case and be sure the rubber gasket is properly positioned. This will give you the best chance of retaining the waterproofing. And remember to check that the watch is running before you do this. Some need to be reset (usually with a very small screwdriver or pin) after replacing the battery. There should be a small hole with some printing next to it. You may need a magnifying glass to see/read it. Good Luck, Richard
Posted on Sep 28, 2007
SOURCE: Replaced battery, now no beep.
I have a Timex Digital Heart Rate Monitor 585 (product code T5C351F5)m, which has the same Short AC Pad and battery +ve message. There is an arrowhead pointing to the pad. It's a raised metal platform - a bit different to some of the Ironman's mentioned above. Here is a pic...
Posted on Jul 06, 2008
SOURCE: watch goes slow when wearing
There is nothing wrong with your watch. Probably it's the one measuring heart rate and pulse (heart beats per second).
Use your users manual to set the watch.
By the way: Timex is one of the worst watch producers.
Posted on Jan 07, 2009
Click on my profile (escapement), then click on Tips and Tricks. There you will find link to all TIMEX watch manuals. Rate me, plz.
Posted on Feb 18, 2010
Click on my profile (escapement), then click on Tips and Tricks. There you will find link to all TIMEX watch manuals.Rate me, please.
Posted on Mar 28, 2010
Tips for a great answer:
Aug 31, 2018 | Timex Watches
Oct 01, 2012 | Timex Indiglo Analog Watch
Jun 14, 2011 | Timex T56381 42 Lap Ironman Triathlon...
Jan 18, 2011 | Timex Ironman T56371 Wrist Watch
Sep 28, 2010 | Timex T41341 Expedition Outdoor...
Mar 28, 2010 | Timex Watches
Aug 15, 2009 | Timex Ironman Triathlon 42 Lap Combo Dual...
Jul 08, 2019 | Timex Watches
May 26, 2019 | Timex Watches
197 people viewed this question
Usually answered in minutes!