Question about Whirlpool Washing Machines
We need the brand and the model
but for starters, please check on the links below.
Posted on Sep 10, 2009
I have the same problem...the solution is called new washer. I was told it could be overhauled to the tune about $600...barrings are going out. Mine is just 7 years old and that's disappointing.
Posted on Apr 03, 2009
Make sure all springs are still in their place tilt the machine back and look under it and you can see them. 2nd all legs must be level as well as the floor.
Posted on Dec 30, 2008
Usually this is due to either the drum support breaking or the back bearing being bad-neither easy to fix- or worth it. Try lifting the drum up and down, if it moves up and down they are bad. I see this a lot, and the price of repair isn't worth it. Craig
Posted on Aug 02, 2009
Unless your front loader is set firmly on concrete
and leveled to perfection, the force of a heavy wash load spinning in
excess of 1000rpm will create a bit of vibration and noise.A firm footing is your best defense against to much movement.
Also due to the earlier movements during the spin cycle, the shocks that are used to dampen the spin cycle might have been broken or damaged.
If the problem persists inspite of proper levelling, please do check for the shocks or might have them replaced them for good.
Posted on Dec 14, 2008
Tips for a great answer:
Feb 23, 2018 | Washing Machines
Nov 18, 2012 | Maytag Centennial MVWC300VW 3.2 Cu. Ft....
Apr 24, 2011 | Washing Machines
When my washer did that, I found that the shocks that hold the tub were bad...
Check out this tip I wrote about the noise and vibration that front load washers can make..
Washer Problems Washer noise when spinning
Dec 12, 2010 | Frigidaire GLTF2940E Gallery 3.5 Cu. Ft....
Jan 02, 2010 | Kenmore HE3T Washer
Aug 02, 2009 | Frigidaire ATF6000ES Front Load Washer
Nov 16, 2008 | Maytag Atlantis MAV6000 Top Load Washer
Aug 29, 2008 | Whirlpool AWM8163 Front Load Washer
2,920 people viewed this question
Usually answered in minutes!