How is login and password in router wg 414b-i

Connect a LAN cable from the Netgear to the LAN port on yourcomputer, open a browser and enter the Netgear configuration URL -
http://192.168.0.1
The default login = admin
The default PW = passwordYou can now change the default admin password and configurethe wireless settings.
Go to the wireless configuration and set up the SSID and WPA or WPA2encryption.
Apply these settings to the wireless card in your laptop/computer.
To secure your wireless network from unauthorized access, please click on thislink and follow my instructions :-http://www.fixya.com/support/r3559128-wireless_router_security

If you've forgotten the Router password, then press the Router Reset button (a small point) located next to the Ethernet port on the Router to restore the Router to factory settings.
After resetting the Router to factory defaults, use the default name and password.

Router Login: http://192.168.1.1
Login Name: admin
Login Password: password

The reason why your internet light is red for the actiontec gt701-wg is because it is not yet configure. You need to access the gui of this router. enter the username and password for your internet connection. You can contact your ISP provider so they can walk you through for the steps on how to configure your new router.

The old router has green light because it was already configured by your ISP provider.

IF your are looking for the wireless password then access the router page and go to the wireless settings and get the password

Need more assistance try the link below

Try this link for the manual http://safemanuals.com/user-guide-instructions-owner-manual/ACTIONTEC/GT704-WG-_E

Yes this is a normal method to setup a wireless network.
To set-up and secure the wireless router from unauthorized access, follow these steps :-
1. Connect the wireless router to your computer with a LAN cable.
2. Start your browser and enter the router's configuration URL IP address.
3. Enter the router setup, login and password
4. Change the admin password
5. Go to the wireless settings and change the default SSID and turn off SSID broadcast.
6. Setup encryption key the strongest is WPA2 (if not then WPA).
7. For further security measures - turn on MAC address filtering and enter the MAC address of the wireless cards on the computer/s you want to connect to this wireless router.
8. Record the settings you have made and keep it in a safe place and Save the settings.
9. Configure the wireless cards on the computer/s with the SSID and encryption settings of the router.
10. Remove the LAN cable between the router and the computer then the computers should be able to connect to the router.

you can not configure the router in client mode

You simply access the router's setup page by going to Internet Explorer and type http://192.18.1.1 it will prompt your for password, try admin by default. You can change the security key under the wireless tab and look for wireless security

Need to know if it is wireless password or GUI password?

Press the reset button on the back for around 45 seconds, wait for the router to start up (around 3 minutes) then connect your computer and login with the default username admin and password admin. Make sure your computer is set up to automaticly aquire a ip address and point your browser to http://192.168.0.1 to log in and set up the router. The user manual for your router can be found here

http://opensource.actiontec.com/index.html

All your answers.