My kodak g610 is not printing ink on paper and i have a brand new cartridge

Clean the gold section of the print cartridge's with a wet paper towel.
Also clean the gold surfaces where the cartridge meets the printer.
Wipe the contacts clean with a dry paper towel once you get no ink back on the wet paper towels. Allow about an hour for the printer to dry.
Reinstall the cartridges and try printing.

Hope This Helps.

Zeppelinx12

Probably a piece of the old one is obstring it.

Dear sir
good day
to fix up such problem
Clean the printhead, then print and

1. Verify that inkjet paper is loaded in the paper trays.
2. On your desktop, start the KODAK All-in-One Home Center, then select the Help [?] icon.
3. From the Help menu, select Maintenance, then select Printhead Cleaning. The On/Off light flashes green during the cleaning procedure.
4. When the On/Off light glows a steady green, press Photo + Copy simultaneously to print a demo sheet

and you have to Replace ink cartridges.
IMPORTANT: Make sure you are using KODAK Ink Cartridges. Your KODAK All-in-One Printer is designed to work with KODAK Ink Cartridges. Kodak is not responsible for the compatibility or performance of either non-Kodak brand ink cartridges or refilled ink cartridges. To purchase KODAK Ink Cartridges, go to KODAK Ink Cartridges & Photo Value Packs.

1. Lift the printer access door, then remove the ink cartridges from the printhead.
2. Insert new KODAK ink cartridges into the printhead, then press down firmly until you hear the cartridges click into position.
3. Close the printer access door, then make the same print.

and you can point to the website below for further information
http://www.kodak.com/global/en/service/repair/troubleshooting/troubleshooting.jhtml?pq-path=5224/6198

thanks

Call Kodak @1800 421 6699 and get a new printhead free of cost.....Printhead has gone bad and it is the part in which we install the ink cartridges.It takes the ink out of the cartridges and spit the ink on the papers,...Cheers and Enjoy.

-Try to Unplug power cable for 10secs
-Remove paper try from the printer
-Make sure you are using the extralife paper or the thermal paper that came from the cartridge
-before you put the paper tray on the printer clean first all the rollers of the printer using a clean cloth
-Now if your done put it back now the paper tray
-Plug the power cable back
-Then do a test print.

If these solutions did not solve the issue please call kodak toll free 1 800 235 6325 and have it repair. GudlucK

Hold the transfer button down then hold the left arrow. Make sure the printer is on. Should here some clicking noise. When it completes then remove the ink cartridge.

We had a similar problem and found out that we put in regular photo paper by mistake. You must use the paper that came with the cartridge because the printer dock uses a thermal heat to produce photos. After using that paper the photos were great.

Start here:

http://www.kodak.com/global/en/service/products/ekn033119.jhtml?pq-path=10734
Can I purchase the ink cartridge and the paper separately for my printer dock?...No, you cannot purchase the ink cartridge and the paper separately....FAQ
http://www.kodak.com/eknec/PageQuerier.jhtml?pq-path=10734/7269&pq-locale=en_US

Have you tried cleaning the paper feed rollers with a slightly damp, lint-free cloth? You'll have to remove the paper try first. If that doesn't work you may have to remove the ink cartridge and tighten the roller. I had to call the Kodak technical support to get help with this. Hope this helps.

it is advisable to use a recomended usb cable for your printer dock. you can try also to uninstall and reinstall the printer driver on your computer. just simply follow this steps:

Remove the drivers that your operating system automatically installed on your computer:
-- On your desktop, select Start > Settings > Control Panel > Printers & Faxes.
-- Remove all Kodak printers.
Right-click the printer icon.
Select Delete.
-- On your desktop, right-click My Computer, then select Properties.
-- Select the Hardware tab.
-- Click Device Manager.
-- In the Universal Serial Bus controllers list, right-click USB Composite Device, then select Uninstall.
note: make sure that the only device connected to your computer usb port is your G610 printer dock to make sure that the USB Composite Device that you uninstall is for your G610, most of the devices connected to you usb port has USB Composite Device also.
-- In the Imaging devices list, if any Kodak printers appear, right-click the Kodak device, then select Uninstall.
-- Disconnect the USB cable from your printer.
-- Restart the computer
-- Power Cycle the printer
-- once your computer is ready connect the G610 to your computer
-- check if you have a pop up window display on your computer informing you that your computer found a hardware device
-- you can go to printer and faxes and check if the G610 printer icon is on the list
-- try to make a test print


Verify that your computer is communicating with your printer:
-- Check that your printer is on.
-- verify if the USB cable meets your printer specifications.
-- Check that the USB cable and the power cord are securely connected to your printer and your computer.