Blurry vision on picture

It sounds like you need a new one, but

How do you fix a blurry flat screen TV?

How to Fix a Blurry TV

1. Make sure your picture isn't stretched. Play with the settings of your TV to ensure that the picture you're seeing isn't being stretched. ...
2. Mess with your TV's different sharpness and picture modes. ...
3. Reduce the noise. ...
4. Swap out your cables. ...
5. Unplug. ...
6. Move it around.

Nov 3, 2022

Troubleshoot a Fuzzy or Blurry Picture on Your TV

Apartment Therapy https://www.apartmenttherapy.com > troubleshoot-a-f...
Search for: How do you fix a blurry flat screen TV?

..

You will also find there is colour disorientation in these areas. The reason is that your settings on the york had shifted, also it could be due to failure of the degaussing coil, or if there is any fault with the convergence inside the picture tube which could be a major fault.
Try to degauss, see the picture tube neck for any ring magnets out of alignment, also check the focussing in the rear panel which could have shifted.

Sounds like the convergence board, try replacing the STK voltage regulators and any resistors that may burned or discolored. This problem is causing the power supply to shut down probably.

sounds like a bad light engine, sorry

try this link. It fixed my sony.
www.somelifeblog.com/2007/06/sony-projection-tv-red-line-repair.html

The convergence circuit has failed. It is not a easy fix due to the tear down needed to get to the circuit area. I would call Mitsubishi at 18003322119 to get a Authorized Service Facility to check it out and give you a estimate of repair cost.

Issue is with main tuner since you have two of them. At least the tv is ok but that tuner is fubar.

sounds as if your convergence needs to be set. either through the menu on the tv or remote you need to get to the convergence set screen and you need to line up the crosshairs. this usually happens when the tv is moved or bumped.

What are you looking at on the screen? Before or after the shot? The this point the taking sequence-point camera at scene look in screen blurry image - half press the release - autofocus comes into play- press all the way picture takes.Sharp picture in the taken images what are you doing?

OUR TOSHIBA HAS A DOUBLE VISION/BLURRIE PICTURE. THIS PROBLEM IS ALWAYS THERE. SOMETIMES THE PICTURE IS GREAT, BUT MOST OF THE TIME ITS BLURRIE/DOUBLE. LOOKS AS IF IT ALWAYS ON 3D!! ANY SUGGESTIONS? WE WOULD REALLY APPRECIATE ANY HELP WE CAN GET FROM ANYONE. THANK YOU!