Wd 52525 red lamp light on but new lamp isn't

The lamp cover is not installed properly or the lamp door switch isnt working thats what causes the 32 error.

hello make sure the lamp is fitted securely and the lamp; cover as well this it due to the safety switches hope it helps

regards
shaun

The projection lamp is dead.The tv projection lamp in the tv now,been in the tv like 1 1/2 or 2 years,The lamp life span is over. Require replacing a new projection lamp.

We have runn in to this with this type lamp, And we are a service center so we do hundreds of these. We too have had bad lamps straight from the box so best guess would to take the lamp back Mitshubishi will warenty the lamp for 90 days so act fast

check the lamp

You have a bad DM Board. You need to replace it. Changing the capacitors will not cure the problem. Completely replace the entire board

you have mention that after 10-15 seconds T.V starts up, will you give total description of the T.V within that 10-15 seconds?

Fuse F9A09

I get the same red lamp led indicator, bought the lamp and I am unable to locate the lamp inside the tv, took the lower back panel out and don't see anything that i can make out the lamp housing. is hard to replace the capacitor and where is the power board located. thanks a mill.

I had another problem kinda the same and emailed ctechnicians.com and they gave the fix.