My Memorex DVD Recorder (MVDR 2102) won't open

Troubleshooting Solution




1.Display Message " Please wait" Not
booted
2.DVD-Rom Two-Three times make noise but doesnt spinning
3. Doesn't
open tray, No video OUT


1.Bad Main Board VEP79117
2. Bad DVDROM

3. Bad Prosessor
PCB

1050 0446 1050 0004 0009 0049 0051 0135 0031 0000 0268 0310 0001

I can give you a new one price 100.00 USDollers.
Sarath

Could be a timing issue with the tray mechanism - possible that somebody has given the tray "a shove" to make it close instead of using the open/close button and has put the timing out.or a worn tray loading belt

I had mine for 2 years and within the first 12 months the tray would not always pop out when I wanted it to. Then finally the machine would not recognise the disc type. Its in getting fixed but although the dvd drive and associated pcb have been replaced the guy says it still can't recognise the dvd disc type. Still trying to work it out.

I have two of these dvd recorders and both have the exact same problem where the drive won't open. It opens fine when there is a disc in the tray. So I just unscrewed the cover, press the white part which would be over the center of the disc as it's trying to open, it should then open. Then just make sure there is always disc left in the tray.

Yes, I did resolve my problem, I read one of the other comments and tipped it upside down and shaked it and at the same time Iam pushing the power button and it popped open. Thanks

I can't get the tray to close

Most likely one or more capacitors on the main board went bad. I just fixed one last night with the exact symptom.

Hi I wish I had better news, but the problem you describe is the same problem that 90% or more of the DVD and for that matter CD players we service come in with. I would say that in about 60% of cases, the problem is dust or other contamination on the laser lense. If you have just done some drywall or other such work in your home, then that is likely the problem. Also, pet hair or other debris can be on the disc when loaded (especially if you have kids), and if it falls off and lands on the lense, that too can cause problems. The other most common things are a bad spin motor, (if you can, put your ear to the unit while it says "LOADING" and you should hear the disc spinning.) If the disc does spin up, and it is not dust, then it is likely a bad laser, and usually, the cost of replacing the laser makes repair not economical. You could try buying a laser cleaning disc, but I find they don't work well, and you should not take the DVD player apart yourself if you are not a tech, as the laser can damage your eyes. My advise would be to call around to local repair shops to find one that has a the lowest bench fee to diagnose the unit, and have it checked. Since it is so difficult to make a living repairing consumer electronics these days, because of the low replacement cost, you may even find a shop that will check the unit free of charge! Good Luck!