CPU Heatsink is cool but fan runs fine no display

<p>Removing a processor AMD is a work that can only be done with a screwdriver in less than 30 minutes. The processor AMD is a central processing unit (CPU) with 939 pins, which are connected to the motherboard. Removing the processor is an issue to withdraw from the motherboard with your hands after you remove the heatsink from the chip.<br /> <p> <br /> <p>1. Turn off the computer and unplug the power cord before removing the AMD processor. Unplug the connector on the back of the computer case and remove the screws, the lid of the computer, in the case with a screwdriver.<br /> <p><br /> <p>2. Slide the computer cover and set aside. Pull the cord that connects the heatsink fan on the motherboard with one hand.<br /> <p><br /> <p>3. Lift the lever on both sides of the fan heatsink, so straight up and remove the plastic clips on the sides of the sink on the motherboard.<br /> <p><br /> <p>4. Pull the heatsink and fan on the motherboard and set it aside.<br /> <p><br /> <p>5. Lift the AMD processor motherboard and carefully remove it from the computer.<br />

<p>1. Unpack the heat sink and fan. Stock cooling is very inefficient and often very high. For best results, buy a cooling system for compatible third-party processor. <br /> <p><br /> <p>2. Install the processor as shown in the chart in the manual. The processor cannot be placed in the wrong direction, so do not try to force them, so you bend the pins. If the processor slides into the wall pull-down bar to solve. <br /> <p><br /> <p>3. Apply thermal grease to the top of the processor, the entire chip with a thin layer. Bank must have a sink path of the thermal grease applied to them on the floor. If this is the case, skip this step. <br /> <p><br /> <p>4. Place the heatsink on top of the processor. Slide the metal brackets under the beams to reach the plastic housing of the processor socket. If staples are present, pull the clip from the heat sink and fan block. It must be securely fastened and must not waver at all when you try to move it. The heatsink and fan should be pressed firmly against the processor. Read the notes if necessary. <br /> <p><br /> <p>5. Connect the CPU fan in the exhaust of the fan on the motherboard. Consult your motherboard if you cannot find the correct port. The computer will not start if the processor fan is not connected. <br /> <p><br /> <p>6. Reboot and run some CPU-intensive programs like video games. Monitoring the CPU temperature with Speed Fan or a similar program. Under full load, at a temperature of about 60-70 degrees is acceptable. If the temperature is much higher than this, you may need better cooling.<br />