Hi my sky box works but when I push for a soda all

Try it without the bill acceptor attached to get the machine working. You did not say what kind of acceptor but three flashes often mean a bad sensor in the unit. Another possibility is that it is disabled from the vendor. Check that all the columns have returned to home position if it is a bag vendor. If it is a pop machine then take off the metal cover over the vend motors and CAREFULLY push down on the microswitches to see if the motors run. Pop may fall out as you do this so watch for it. After running all the motors or homing out all the columns try you machine again. You will probably have to get the bill acceptor fixed though.

thats a cool washer!! soda washer!

Try these suggestions:
http://www.vendingadvantage.com/troubleshooting.htm

Have you tried unplugging and reboot it?

Power supply is getting weak, and or the room is way too hot.

I have some panels for sale $25 new in the box. Please see my posting on Craigslist Des Moines Iowa or give me a call 515-707-3551.

Michelle bailey

selection number 7 reads sold out but its full i have a vendo drink machine that is electronic and i push the code button to test then select number 7 vend on first button then third button to test vend and it showed an error failed .what else could i try i need some sujestions. please.

Dont think so
Try resetting it by this method,it might work
To perform a RESET press [TV] and then hold [select] and [red button] together for around two seconds (until the red light blinks twice). Now press 999 (red light blinks once for a long time and then twice quickly).

Please let me know if this helps
JonnieC

I have a service manual on the sky box post your email and i will send it to you

I have intermittent problems with one dispenser and disassembled the system and swapped drive motors for the dispensers. The problem followed the motor. Partselect.com shows that they sell the individual rack assemblies but I have not yet ordered one. I am trying electrical supply stores to see if I can just buy the motor but I doubt they will be able to track it as it has no markings.