Which is hot wite red or black - Dryers

is this a problem with your screen

not much you can do with them but try to dye them blue again, once blue gets wite lines in them hard to cover the lines again with blue.
might have way better luck turning them to a black color instead.black covers way better and might even work perfect.
use hot water with any dye you use for better results and add about a table spoon ovv vinagar to help it along, good luck,
Gary

try to self clean your printer then test print

search youtube for your model number for the wiring schematic for your model clippers

1) Copy following link for wiring gfci
http://waterheatertimer.org/How-to-wire-GFCI.html

2) Add a comment March 2013 and say what voltage you are wiring, and what the wires connet to.

If you need further help, I’m available over the phone at https://www.6ya.com/expert/gene_9f0ef4df2f9897e7

Yellow: battery constant 12v Red: Ignition 12v Black: GND ground White and White with Black stripe: Left front speaker. White is positive (+) Grey and Grey with Black stripe: Right front speaker. Grey is positive. (+) Green and Green with Black stripe: Left rear speaker. Green is positive. (+) Purple and Purple with Black stripe: Right rear speaker. Purple is positive. (+) Blue: Antena remote turn on. Blue with Wite stripe: Amplifier remote turn on. I think thats all of them. Make sure to connect your positives and negative correctly or you will have phasing problems. dreamsystems

Smoke can be from rings worn out, cracked piston, valve guide seals if smokes at start up then stops, fueling issues if fuel is to rich but that smoke is usually black, also if head gasket is blown or head is cracked water burning turns into steam which looks like white smoke. This can also be why won't start just turns over.

are you sure you have the right plug?wite wires are normaly found only on 120v and 347v systems. but if it realy is 240v then black to black, red to wite and yellow/green to green.

Place to connectors with same color wire.

If you have a four prong recepical then the receptical has 2 hot wires, 1 neutral and 1 ground black and red are hot wite is nuteral and green is ground.

The connection on the back of the dryer will be white on the center screw, green to the frame of the dryer, and black and red to the outside screws of the terminal block, and it does not matter which color black or red goes to the left screw, or to the right screw, you choose