Kenwood kvt-m700 schematic for monitor power connector

pretty basic red is pwr yellow is constant blk is ground and the green wire well just ground out that out too

Hi
Guess your car's wires haven't been cut. Go to any stereo shop and get the harness that's specifically for your car. The colors on it will match all the colors on the clarion harness. Connect like colors, plug in, and you're done.
Please check the below mentioned site for the wiring diagram which will help you for the installation.
http://www.tehnomagazin.com/Auto-radio-car-connector/KENWOOD-Car-Radio-Wiring-Connector.htm

please let us know for further query.
Thankyou for contacting fixya.com.

You don't need a code, it's unlocked by the remote that came with the unit (small purple one)

The only way to play DVD's on your M700 is to have the handbrake on. Although you can get round it by plugging the DVD into the second set of connectors (AV2) instead of the first (AV1).

The M700 is purely a monitor so you will not be able to control play, pause, stop, skip, FF or RWD. I use my DVD player as a CD player and have to use the DVD remote to change tracks.

Sounds like the board inside the unit is on it's way out.

You can send it off to a company on ebay who will de-activate the code for the stereo.

Bu the sounds of it, you will only need to enter the mask code if the memory wire becomes disconnected, so I would assume that you have your power(red) and memory/constant 12v backword, or both hooked up to the power wire

The unit is clipping which means it's too loud, lower the volume and should be fine.

edgar duran i know u stold the radio u r a f***n thief