Question about Kenwood Car Audio & Video
SOURCE: kenwood KAC-PS201T
The first thing you must do is to confirm that you have voltage at the amp. Just because the fuses look good, that doesn't mean you're getting power to the amp.
With your multimeter set to DC volts, the black meter lead on the ground terminal of the amp and the head unit on (so the amp will have remote voltage applied), touch the red lead alternately to the B+ and remote terminals of the amp. If the voltage is below ~11 volts, you need to check the wiring feeding whichever line is too low.
Posted on Jan 22, 2008
SOURCE: DNX7100 microphone
hi rob there is no way u can pair ur keenwood to your phone. your still going to need a microphone so that your callers can hear you. i installed the same unit in my durango a year ago and had the same problem. the only thing to do is keep using the earpiece.
Posted on Feb 13, 2008
SOURCE: To bridge a Kenwood KAC-9102D
The Kenwood KAC-9102D is a mono amp. There is no bridging. Having two sets of terminals is just a more convenient way of connecting two subwoofers. The amp is stable down to 2 ohms impedance, so it is safe to run 2 4 ohm loads in parallel.
Hope this helps.
Posted on Apr 28, 2009
from what i have read about your amp, it is already a mono amp, and rated for 2 ohm's, so all you have to do is wire the subs in parallel (both positives together to positive and both negatives together to negative) or series/parallel if you have dual voice coils (both positive and both negative paired on each sub, then positive from amp to positive on one sub; negative on that sub to positive on next sub; then negative on sub to negative on amp) Note though, with two dual voice coil subs, you can have a 1 ohm load with the first set up, which can damage your amp. Let me know if this helps :)
Posted on Jun 11, 2009
from your sub connect one short piece of cable from + on one side to - on the other side using the same diameter cable as you are running to the sub from amp . this will leave you with + and - on opposite sides of speaker these will then run to the amp +to+ and - to- on the mono side of connetor which is one left + and one - right and the amp switched to bridged
Posted on Sep 03, 2009
Tips for a great answer:
Nov 12, 2014 | Car Audio & Video
Jun 11, 2009 | Kenwood KAC-719 Car Audio Amplifier
Mar 25, 2009 | Kenwood KAC-8151D Car Audio Amplifier
Dec 15, 2008 | Kenwood KAC-9152D Car Audio Amplifier
Aug 24, 2008 | Kenwood KAC-9102D Car Audio Amplifier
Feb 03, 2008 | Kenwood DNX7100 Car Video Player
Aug 08, 2007 | Kenwood KAC-8403 Car Audio Amplifier
Nov 05, 2006 | Kenwood KAC-728S Car Audio Amplifier
117 people viewed this question
Usually answered in minutes!