Moyer Diebel 401ht water runs after load is done

The thermostat for the final rinse booster might be set too high causing the water to boil in booster tank. Water will then spray even when cycle is complete. Turn the thermostat down to 180f or 82c to comply with health regulation. If problem continues replace booster tank thermostat. Or if you have hard water pull thermostat and clean

what I can tell you is that if the water temp is not high enough say 120 deg, the dishwasher washing cycle will extend.chk your drain hose and float valve for fill drain issue.

I’m happy to assist further over the phone at https://www.6ya.com/expert/phillip_77d32603f8052503

Best way is to contact a chemical supply company and have them do it. The delime product should not be mixed with chlorine.

yes it's a good deal , so long as the wash pump works ok.

Hi,
Here is a tip that I wrote that will help you with your dishwasher not drainingproblem...

Dishwasher Problems - Waterwill not drain out

heatman101

A service man might have a used one kicking around. Or buy new.

yes you can. but nothing will be sanitized

If the temperature was ok before, and no one has adjusted the thermostat, then that is an indication of a thermostat that needs to be replaced.

The pump and motor comes as one unit. Motor does not come seperate. Pump parts can be sold seperately

could be a number of problems. Checking with an ohm meter would determine the problem. Could be the booster high limit thermostat, a burnt wire, booster thermostat, or a heater element.