How to stop my laziboy recliner from rocking - Furniture

stop rocking back and forwards and it won't rock....

Apex Reclining Motor Model AP A88 ' eBay

m.ebay.com/itm/201272942152?cmd=VI_SPR
Apex reclining motor- model- AP-A88 in Home & Garden, Furniture, Sofas, Loveseats & Chaises ' eBay.

What is the problem with the rocking chair?

The downside of reclining rockers is that because they are much more complex than traditional rockers, they are more likely to break.

Hi

No the grey recline / remove button on the back of the Zapp Xtra seat unit cannot be repaired. It would be a case of replacing the seat unit.

There are three types of recliners you can look for: recliners with legs, European recliners and compact recliners. I have found you a site with a few of these options to browse through. I hope something will fit your space.

http://www.wayfair.com/Recliners-C413904.html?refid=ss222500

http://www.wayfair.com/Rissanti-Barstow-Push-Back-Recliner-in-Black-30095-GSC1031.html?refid=ss222500

Mark, try moving the seat back itself, rocking it back and forth whilst operating the tilt lever, you may need an extra hand

The problem:
The set belt stop has been lost so the seat belt retracts too far when the seat is laid flat. When laid flat the release mechanism locks as it should when not level so the seat cannot be raised up as the belt is too tight and locked.
The Solution:
1) Push the two little clips to release and remove the headrests.
Pull the grey lever on the right of the seat base, lift seat base up and forward toward the front seat..
2) See two red capped leversat the back of the two seat hinges and lever them to the upward position, this releases the seat.
Rock the very heavy seat unit upwards and lift complete unit upwards.
3) Take it out of the car and turn 180% so that the back of the seat and base are in the upward position and the seat belt will pull out as it should
4) Replace the missing belt locking stop (I used a tie pin permanently fixed using super glue).
5) Fold seat back down and test then either re-fit seat unit or leave out to decrease fuel consumption..