I have a candy AQ 1200, it fills with water then drum turns and s

Water valve on washer bad

Could be the circuit board at fault

Presoatat, or the pipe to presostat is cloged.

Check your drain line. It is more than likely pushed too far down into the drain line causing the machine to siphon water out as its going in.

If you need further help, I’m available over the phone at https://www.6ya.com/expert/jason_4570d45317834dd3

hi there, it sounds as if your drive belt is loose or broken. when you put you ear to the machine can you hear the motor running, if the motor runs but nothing else happens its a sure sign that the belt is gone. whilst you might look silly doing this, it may prevent you opening the machine up to replace the belt if you not have to.
thanks iain

It could be the motor itself (is there any overheating smell from the motor) or it could be the capacitor which controls the motor. I had a similar problem and it turned out to be the motor brushes. I replaced the brushes and all was OK.
The only other thing that could be wrong especially if it overfills with water is the water level switch (this is a pressure switch on the side of the washer) You can easily check this by removing the hosepipe to the switch and blow gently into it, you should hear a clicking sound) This might be the clicking that you heard so it is probably Ok.

it is rubbing on spin cycle due to being out of balance.Rubbing wont occur when turning by hand.
Stop by your local hardware store for a packet of drum balancers.

although not famillar with your particular model. if its filling with water when not even turned on you have a bad water inlet valve.no servicing just replace

problem may just be that drum is not turning so you think program is stopped. try cancelling and select spin program and see if you get spin