My canon Shelby CP910 keeps reading low battery.what does this mean and how can I fix it?

Are you using Canon 4x6" PCP-CP400 Postcard Size Paper Cassette for SELPHY CP900/CP910 Dye Sub Printers??? Is the paper Matte or Glossy

Is the paper upside down?

Did you fan the paper at least 3 times?

Canon SELPHY CP910 Printer Drivers Download Selphy Printer

I am having the same issue with my cp910 and i believe it is caused by dust inside that for whatever reason is not coming out when running multiple prints to try and clear it. I have looked up a couple of videos to help me take apart mine but the cp910 seams to have a security screw in one of the corners but i think you'll find that yours does not and you should be able to take it apart fairly easily to give it a clean and that should hopefully sort your problem :)

i have selphy cp910 coming option paper size incorrect why.pls can you any solation

hello i got a 1990 dodge daytona shelby the code 13 is MAP sensor signal to the computer (ECU) not changing so the map sensor is should be on the firewall with a vacuum line on it little black box looking thing well make sure it plug in and good and that it dose not have a leaking vacuum line if that dose not work you have a bad map sensor thay run about 30 to 100 at auto zone o onec you think you fix it remove the battery term for about 5 mins with the key on and trun the key off before conttecting the battey back up drive for about 20 mins to see if the code show up if you get code 55 all that means is end of falt code list you mite get a code 12 meaning The battery has been disconnected and the computer (ECU) has been reset hope that help keep that daytona runing it a good car

cudgegong said in another forum:

To resolve the annoying "change the batteries" problem. Goto menu, choose yellow menu, select
file No. reset to ON. Turn camera off and back on.

Voila fixed.

Hello.
E000 means :
"The main thermistor reading does not reach 40oC 14 sec after the fixing heater goes ON (fixing low temperature error)"

P1633 means KAM (Keep Alive Memory ) Voltage too low. the KAM is caused by low battery voltage and you replace the battery.When you replace the battery the KAM loses Memory and the problems resulting in what you are experiencing now.When replacing a new battery, reconnect the Positive cable first.And use a trickle battery charger set low to the cables before disconnectng the battery . this will keep the voltage to the ECM powered with enough voltage. All you can do now is make the computer relearn the way it should run. Disconnect the negative cable from the battery, wait a while 20 seconds or so. then reconnect the cable. I do not know if this is a temporary fix or not but it should re-program the computer.

I had the same prolem. OK, try this. Try to discharge the AA batteries in some use, flashlight or else,,,,then recharge them, full charge, install the batteriers ...they should work fine....
I read somewhere that canon is able free of charge to correct a shortcircuit that the camera is susceptible to develop in the installation of batteries......But I hope the advise will work...
Remove batteries when not in use.

Format the card with the camera. If that doesn't work, format the card as FAT (not FAT32) file system with your PC.