Tryed five times permenantly locked

nice to know
most service providers only allow 3

you may try some default codes........

Contact ur Cell provider and tell ur sim number and they give ur PUK code....don't try three more time ur sim will be permenantly locked

the first owner of that cellphone put that security code, don't try it more than five times by guessing, it might damage your phone permanently

have a cellphone service man do the job, he will use softawre and flashing tolls to remove the lock

i dont know if this will help you but to change the auto lock codes on a 94 mercury sablethat is set into your remote keyless entry system at the factory.you can program your own personal code to unlock the vehicle. this code does not replace the prminant code that is programmed into your system.
to program your own code 1) select five digits for your personal code. 2) enter the code the dealership gave you. 3) within five seconds, press 1/2. 4) within five seconds of pressing 1/2, enter your personal code, pressing each digit within five seconds of the previous digit.
the keyless system registers this second code. to open your vehicle, you can now use either code. the module only remembers only one personal code at a time. entering a second personal code will erase the first personal code, replacing it withe new second one.
to erase your personal code 1. enter the original code. 2. press1/2 within five seconds of step 1. 3. wait six seconds
the keless entry system auto erased your personal code and will only respond to the permenent one. i hope this helps

1. Enter the five digit permanent entry code into keyless entry keypad.
2. Within five seconds of pressing last button of permanent code, press the 1/2 button within five seconds of pressing the last button of the permanent code. (Factory code found on the module).
3. Enter any alternate five digit code within five seconds of pressing 1/2 button.
   • Enter a sixth digit as follows to indicate operator's memory seat setting to be set by alternate code: 9/0-- no memory recall
     1/2-- memory seat position 1
     314-- memory seat position 2
     5/6-- memory seat position 3
     
   • After successful programming, the doors will signal by locking and then unlocking.
   
   

The Keyless Entry Module is located inside the drivers side door.

try to format the mobile by switching it your pc with usb so the code will be unlockes but your data will be deleted.or else contact your service provider and ask the puk code no and insert that puk no into your mobile it will be unlocked.

It must be sent to LG to be unlocked. It takes only 3 tries and it locks forever. Manufacturer is the only one who will do it safely and right.

Hi the problem is due to it been wired in wrong their should be two live wires coming from the unit one is permenant live this stores the time and any setings you change and the other live is main live that turns the unit on when ignition is on.
What you need to do is locate these live wires they will either be wired up to one live wire coming from the car this causing the problem you need to have one live wire going to live auxilary and the other should goto a permanent live wire.
The permanent live wire is the one that stores the time and setting etc it usually an orange wire and the permanent live wire is usually red.
What you can do is use search engine and look for wiring diagramme for your unit this will show you whats permanent live and what aux live hope this is some help.
If you are unsure let some one look at it for you its only five minute job thats all ok

have you tryed a hard reset?

if the phone is still locked after a hard reset the device needs to be flashed with a new system.